navigation system: component tests and general … · 4-2-2014 · 5.verify the sensor output...
TRANSCRIPT
2010 Mazda Truck CX-9 AWD V6-3.7L Copyright © 2011, ALLDATA 10.40 Page 1
Navigation System: Component Tests and General DiagnosticsNavigation Check - Car-Navigation System
NAVIGATION CHECK [CAR-NAVIGATION SYSTEM]
Inspection item list
GPS Information
1. Turn ignition switch to ACC or ON position.
2. Launch the diagnostic mode. See: Reading and Clearing Diagnostic Trouble Codes/Starting Procedure For Diagnostic Mode - Car-NavigationSystem
3. Select "Navigation Check".
4. Select "GPS Information".
5. Verify the GPS information.NOTE:- The GPS reception signal is updated every 1 s.
2010 Mazda Truck CX-9 AWD V6-3.7L Copyright © 2011, ALLDATA 10.40 Page 2
6. To stop the on-board diagnostic mode, turn the ignition switch to the LOCK position.
Vehicle Sensors
1. Turn ignition switch to ACC or ON position.
2. Launch the diagnostic mode. See: Reading and Clearing Diagnostic Trouble Codes/Starting Procedure For Diagnostic Mode - Car-NavigationSystem
3. Select "Navigation Check".
4. Select "Vehicle Sensors".
5. Verify the sensor output condition of the sensor being input to the car-navigation unit.NOTE:- The vehicle signal is updated every 1s.
6. To stop the on-board diagnostic mode, turn the ignition switch to the LOCK position.
History
1. Turn ignition switch to ACC or ON position.
2010 Mazda Truck CX-9 AWD V6-3.7L Copyright © 2011, ALLDATA 10.40 Page 3
2. Launch the diagnostic mode. See: Reading and Clearing Diagnostic Trouble Codes/Starting Procedure For Diagnostic Mode - Car-NavigationSystem
3. Select "Navigation Check".
4. Select "History".
5. Verify the displayed content.
6. To stop the on-board diagnostic mode, turn the ignition switch to the LOCK position.
Microphone Check
1. Turn ignition switch to ACC or ON position.
2. Launch the diagnostic mode. See: Reading and Clearing Diagnostic Trouble Codes/Starting Procedure For Diagnostic Mode - Car-NavigationSystem
3. Select "Navigation Check".
4. Select "Microphone Check".
5. Verify the microphone input condition.
6. To stop the on-board diagnostic mode, turn the ignition switch to the LOCK position.