navkal - 7.0 navistar x233a evaluebid - home...navkal is an electronic control module (ecm)...
TRANSCRIPT
NavKal is an Electronic Control Module (ECM) Programming Software that replaces all previous PC based ECM Programming Software (Nets, AutoUpgrade). Software Features:
Offline Calibration updating
Parameter and Horse Power changes
Program a Blank Module
On-screen display of vehicle information, Including ECM software Version and Upgrade availability
Read and Clear Engine DTCs
Create Programming Verification Code (PVC)
Requirements:
Supported EZ-Tech (Win XP or later)
RP1210B diagnostic interface cable and latest supported drivers
Efore luc
QUICK REFERENCE Tips for NavKal
Before connecting to a vehicle, Select Diagnostic Interface under tools
Before using NavKal for the first time, you must Enter Dealer
Information
Select “Update Dealer Information” under File on the Menu bar.
Enter Dealer info and click “Save”
NavKal OVERVIEW
To begin updating, Select “Update Calibration” and Follow
Screen prompts for key cycles.
If calibration update is available, Existing and New Calibration
will be displayed.
Battery Voltage must be above range to begin
programming, NavKal will display highlighted voltage,
RED = 9.0 – 10.4 Volts YELLOW = 10.5 – 12.4 Volts GREEN =
12.5 Volts or higher. Install the Midtronics SMART Charger
before programming. See SFN 07-11 for details.
1
2
2
SECTION 1
Connecting to a Vehicle and Updating Calibration Version
1
3
Select or click on the “Parameter Upgrade” tab.
Enter Associated Case File Number.
Select “Save Request” and follow screen prompts
Note: See Section 4 “Process Request”
Return to Campaigns tab to complete update
Note: Case file must be completed before this step
2
1
SECTION 2
Update/Change Parameter and Horsepower
3
4
Input Associated Case file and vehicle information, all fields must be
populated
Select “Save Request”
Select “Blank Module Flashing” tab.
Note: Case file must be completed before this step
Select Engine Platform Select module being replaced
2
SECTION 3
Blank Module Flashing
1
3
4 5
After “Process Request” is complete and Status shows
Downloaded. Return to “Campaigns Tab” to complete update
Select “Flash Blank Module”
Select VIN
”
Follow Screen Prompts for Key Cycles
8
9
SECTION 3 (Continued)
Blank Module Flashing
7
10
Select “Process Request” Tab.
Note: Request type and status are displayed for each vin.
Select “Process Request” to complete all pending requests.
Note: Request type and status are displayed for each vin.
SECTION 4
Process Request
1
1
2
Select Recovery.
Select associated VIN
.
Follow screen prompts for Key Cycles. NavKal screen
prompts will become highlighted.
RED = Cycle Key OFF YELLOW = Cycle Key ON
Note: In the event of programming failure
SECTION 5
Recovery
1
3
2
Select Process Request to send history & create a Programming
Verification Code (PVC), a PVC will be generated against the associated
(VIN) number
Select view PVC to view or print PVC
Note: After programming is complete under Process Request Tab, status will show
pending PVC.
SECTION 6
Programming Verification Code (PVC)
1
2
1