NBC CTT Tasks

Presented by:

Tasks

• Implement MOPP Level 0-4

• DECOM Skin and Equip

• Don Protective Mask

Protect Yourself From NBC Protect Yourself From NBC Injury/Contamination With The Injury/Contamination With The Appropriate Mission-Oriented Appropriate Mission-Oriented

Protective Posture (MOPP) GearProtective Posture (MOPP) Gear

031-503-1015031-503-1015CONDITIONSCONDITIONS

You are at MOPP level 0. Given MOPP gear (chemical protective Over garment, mask, hood, over boots, protective gloves, individualDecontamination kits, and antidotes) and one of the following Situations where you:

• Are ordered to do so,• Learn a chemical attack is about to happen• Must enter an area where chemical agents have been used.• Recognize a chemical hazard.• Are attacked with chemical agents without warning

STANDARDSSTANDARDS

Achieve MOPP level 4 within 8 minutes by performing all steps in sequence

MOPP LEVEL 1

1. Put on MOPP gear for MOPP 1

a. Don the trousers1. Put on the overgarment trousers over your normal duty

uniform or over your undergarments in hot weather2. Secure the trousers by snapping and zipping the trousers and

adjusting the waistband for a snug fit

b. Don the jacket1. Put on the overgarment jacket2. Zip it up3. Fasten the snaps

c. Secure the jacket to the trousers by snapping the three snaps across the back of the jacket to the trousers

MOPP LEVEL 2

• Put on additional MOPP gear (protective overboots) to reach MOPP 2

A. Put the older model chemical protective overboots on over the leather combat boots (Note: The older model has a single eyelet at the rear)

a. Don the cover on either foot by centering your foot on the soleb. Lace through the front eyelet so the ends are the same lengthc. Tie a single hitch by passing one lace end through each eyelet from the inside to the outside, drawing each lace end tightd. Pass both ends through the rear eyelet from in the inside oute. Bring the ends back through the side eyelets

B. Tie the lace tightly across the instep with a single hitch

C. Wrap the excess lace around your leg, tying the ends with a bow

Note: The lace should hold the rear eyelet firmly against the boot

D. Blouse the overgarment trouser legs over the protective overboots

E. Secure the Velcro closures of the government trouser legs by zipping and tying the drawstrings firmly

MOPP LEVEL 3

3. Put on your protective mask with hood to reach MOPP 3

a, Don the protective mask

b. Don the hood

c. Zip up the hood

d. Adjust the neck cord

e. Attach the underarm straps

Note: The time standards for masking do not apply to this task

The “buddy system” is encouraged

MOPP LEVEL 4

4. Put on additional MOPP gear to reach MOPP 4

a, Secure your MOPP gear by zipping all zippers and closing all closures

b. Put on the chemical protective gloves (rubber gloves and liners)

c. Pull the elastic cuffs of the overgarment jacket sleeves over the cuffs of the chemical protective gloves.

5. Additional MOPP posture is “mask only” (mask worn). This posture is not appropriate when a blister agent is present

Decontaminate Yourself and Decontaminate Yourself and Individual Equipment Using Chemical Individual Equipment Using Chemical

Decontamination KitsDecontamination Kits

031-503-1013(1007)031-503-1013(1007)CONDITIONSCONDITIONS

You are at Mission-Oriented Protective Posture (MOPP) level 2 with remainingMOPP gear available and have a full canteen of water, a poncho, LCE, and an M258A1 Decontamination kit. You have???

• Been attacked with chemical agents

• Passed through an area contaminated with chemical agents

• Been exposed to radiological contamination

STANDARDSSTANDARDS

Start the steps to decontaminate your skin and/or eyes within 1 minute after you find they are contaminated. Do not breathe while decontaminating your skin or eyes. Remove all contamination from your skin. Decontaminate all personal equipment after decontaminating your skin, face, and/or eyes.

1. Assume MOPP Level 3 (Don your mask and hood)

• Seek overhead cover or use your poncho for protection against further contamination

• Decontaminate your hands with decontaminating wipe 1

a. Open the decontamination kitb. Remove one decontaminating 1 packetc. Fold the packet on the solid line marked BENDd. Unfold the packete. Tear open the packet at the notchf. Remove the wipe, fully unfolding itg. Wipe your skin, starting with your hands (wiping downward)

• Decontaminate your eyes, if necessary.

a. Check your canteen for contamination (first)1. Remove your canteen from your LCE2. Unscrew the cap, avoiding possible contamination of the canteen by

pushing up on the bottom of the canteen cover until you can grasp the canteen3. Check the canteen mouth for contamination using M8 detector

paper.a. If contaminated, obtain an uncontaminated canteenb. Decontaminate the canteen mouth with M258A1 kit

b. Unseal your mask as follow:1. Hold you breath, close your eyes, lift the hood and mask from your

chin

c. Flush your eyes with water from the canteen

d. Secure your mask by??1. Resealing it2. Clearing it3. Checking it

e. Breath

5. Decontaminate your face. if necessary, with a decontaminating wipe 1.

a. Unseal your maskb. Wipe up and down from ear to ear

1. Start at your ear2. Wipe across your face to the corner of your nose3. Wipe across your face to the other ear

c. Wipe up and down from your ear to the end of your jawbone1. Begin where step b ended2. Wipe across your cheek to the corner of your mouth3. Wipe across your closed mouth to the center of your upper lip4. Wipe across your closed mouth to the corner of your mouth5. Wipe across your cheek to the end of your jawbone

d. Wipe up and down from one end of your jawbone to the other end of your jawbone

1. Begin where you ended in step c2. Wipe across and under your jaw to your chin, cupping your chin3. Wipe across and under your jaw to the end of your jawbone

e. Turn your hand out and quickly wipe the inside of the mask that touches your face

Note: Do not wipe the mask lens. The decontaminating solution may leave a film on the lens.

f. Secure your mask.

1. Resealing, clearing, checking.

g. Breathe

• Decontaminate your neck and ears, if necessary, using the same decontaminating 1 wipe

• Decontaminate your hands again with the same decontaminating 1 wipe

• Bury the wipe if time permits

• Prepare the decontaminating 2 wipe

a. Pull out one decontaminating 2 wipe packetb. Crush the enclosed glass ampule between your thumb and fingers without kneadingc. Fold the packet on the solid line marked CRUSH AND BENDd. Unfold ite. Tear the packet open quickly at the notchf. Remove the wipeg. Open the wipe fullyh. Dispose of the crushed glass ampule by burying it

• Repeat steps 5 through 8 using the decontaminating 2 wipe

• Put on your protective gloves

• Fasten your hood

• Make sure all skin areas you have decontaminated are covered

• Decontaminate your personal equipment

Note: Do not use the decontaminating kit on protective garments

a. Decontaminate weapons, gloves, helmet and hand tools using decontaminating 1 wipe first, then decontaminating 2 wipe

b. Decontaminate the exterior of the hood and mask1. Wipe eye lens outserts using a decontaminating 2 wipe2. Begin wiping the hood at the top working your way downward3. Repeat

A. andB. above using decontaminating 1 wipe

Note: Using the wipes in the order will prevent a residue from forming on the eye lens outserts.

15. Remove radiological contamination from your clothing, equipment, and exposed skin if necessary

Protect Yourself From Protect Yourself From Chemical/Biological Contamination Chemical/Biological Contamination

Using Your Assigned Protective MaskUsing Your Assigned Protective Mask

031-503-1035 (1025)031-503-1035 (1025)

CONDITIONSCONDITIONSYou have your assigned M40-series protective mask with hood.You find yourself in one of the following situations where you:

• Hear or see a chemical or biological alarm that indicates the Presence of an agent.• Realize otherwise that you are under a chemical or biological Attack3. Are ordered to mask

STANDARDSSTANDARDS

Don your protective mask with 9 seconds (including clearing and checking the mask). Pull hood over your head and zip the front

closed to cover all your bare skin

• Don your mask within 9 seconds

• Don the hood so it lies smoothly on your head

• Remove your protective mask with hood after the all clear order is given

• Store your mask with hood

WARNING

DO NOT WEAR CONTACT LENSES WITH THE PROTECTIVE MASK.