Setup Guide

CSR102x Professional Development KitBluetooth® Low Energy Single Mode SoC

© 2017 Qualcomm Technologies International, Ltd. All rights reserved. Qualcomm is a trademark of Qualcomm Incorporated, registered in the United States and other countries. The Bluetooth® word mark and logos are registered trademarks owned by Bluetooth SIG, Inc. and any use of such marks by Qualcomm Technologies International, Ltd. is under license. Other products and brand names may be trademarks or registered trademarks of their respective owners. This technical data may be subject to U.S. and international export, re-export, or transfer (“export”) laws. Diversion contrary to U.S. and international law is strictly prohibited.developer.qualcomm.com

Next steps and support for your Professional Development Kit

The system is now ready to be programmed using the installed SDK.Example projects are supplied in the “apps” directory of the SDK installation path. Open the project of your choice. Once programmed, the system can be connected to any suitable host.

Community forumshttps://developer.qualcomm.com/forums/qdn-forums/hardware

Product infohttps://developer.qualcomm.com

80-CE181-5 Rev.A

04 05

02 03

01 CSR102x Professional Development Board

02 Radio Module

03 USB cable For programming and debugging connection to host PC

04 CSR8510 USB Dongle

05 Jumper cables For on board UI (LEDs, Button and Buzzer)

06 Flat programming cable For programming external boards (not included)

Setting up and connectingthe development hardware

Component list

A. Simple UI B. Application plug in board connector C. Developer board connectors D. Configuration jumpers

H. Antenna I. SoC

E. Flat programming cable connectorF. USB connectorG. Current measurement and power selection

01 Dowloading the SDK requires registration. The packaging of the Professional Development Kit contains an activation code.

For instructions on how to complete this process, visit:

https://developer.qualcomm.com/csr102x-activation

02 Ensure all software is installed before connecting any hardware.

It is recommended to accept all default options during installation.

Note: Ensure the software is installed on the development PC before proceeding

01 Remove both the programmer board as well as the radio module from the anti-static packaging at an appropriate workstation.

02 Plug the radio module onto the programmer board at CON3 / CON4.

03 Connect the professional development board to the development PC using the mini-USB cable.

04 The device drivers necessary to connect to the target board should already be installed on the PC as part of the SDK installation.

Note: Ensure that the radio module is connected in the correct orientation before powering on the board, as shown below.

This Setup Guide helps you set up and use your CSR102x Professional Development Kit

Downloading and installingsoftware on development PC

01BA C

G

B CDF E

06

Radio ModuleCSR102x Professional Development Kit

I

H

Radiomodule

connectors