NOA No. 17-0307.09

Expiration Date:

Approval Date:

Page 1

MIAMI-DADE COUNTY

PRODUCT CONTROL SECTION

DEPARTMENT OF REGULATORY AND ECONOMIC RESOURCES (RER) 11805 SW 26 Street, Room 208

BOARD AND CODE ADMINISTRATION DIVISION T (786) 315-2590 F (786) 315-2599

NOTICE OF ACCEPTANCE (NOA) www.miamidade.gov/economy

CGI Windows & Doors

10100 N.W. 25th Street

Doral, FL 33172

SCOPE:

This NOA is being issued under the applicable rules and regulations governing the use of construction

materials. The documentation submitted has been reviewed and accepted by Miami-Dade County RER -

Product Control Section to be used in Miami Dade County and other areas where allowed by the Authority

Having Jurisdiction (AHJ).

This NOA shall not be valid after the expiration date stated below. The Miami-Dade County Product Control

Section (In Miami Dade County) and/or the AHJ (in areas other than Miami Dade County) reserve the right

to have this product or material tested for quality assurance purposes. If this product or material fails to

perform in the accepted manner, the manufacturer will incur the expense of such testing and the AHJ may

immediately revoke, modify, or suspend the use of such product or material within their jurisdiction. RER

reserves the right to revoke this acceptance, if it is determined by Miami-Dade County Product Control

Section that this product or material fails to meet the requirements of the applicable building code.

This product is approved as described herein, and has been designed to comply with the Florida Building

Code, including the High Velocity Hurricane Zone.

DESCRIPTION: Series “560” Aluminum Sliding Glass Door w/ wo Reinforcements – S.M.I.

APPROVAL DOCUMENT: Drawing No. W08–21, titled “Series 560 Alum Sliding Glass Door – SMI”,

sheets 1 through 13 of 13, including sheets 2.1 and 9.1, dated 05/23/08, prepared by Al–Farooq Corporation,

with latest revised “G” dated 12/21/15, signed and sealed by Javad Ahmad, P. E., bearing the Miami–Dade

County Product Control Renewal stamp with the Notice of Acceptance number and Expiration date by the

Miami–Dade County Product Control Section.

MISSILE IMPACT RATING: Small Missile Impact Rating.

LABELING: Each unit shall bear a permanent label with the manufacturer's name or logo, city, state,

model/series, and following statement: "Miami-Dade County Product Control Approved", unless otherwise

noted herein.

RENEWAL of this NOA shall be considered after a renewal application has been filed and there has been

no change in the applicable building code negatively affecting the performance of this product.

TERMINATION of this NOA will occur after the expiration date or if there has been a revision or change

in the materials, use, and/or manufacture of the product or process. Misuse of this NOA as an endorsement

of any product, for sales, advertising or any other purposes shall automatically terminate this NOA. Failure

to comply with any section of this NOA shall be cause for termination and removal of NOA.

ADVERTISEMENT: The NOA number preceded by the words Miami-Dade County, Florida, and

followed by the expiration date may be displayed in advertising literature. If any portion of the NOA is

displayed, then it shall be done in its entirety.

INSPECTION: A copy of this entire NOA shall be provided to the user by the manufacturer or its

distributors and shall be available for inspection at the job site at the request of the Building Official.

This NOA renews NOA# 15-0302.07 and consists of page 1 and evidence pages E-1, E-2 and E-3, as well

as approval document mentioned above.

The submitted documentation was reviewed by Jorge M. Plasencia, P.E.

NOA No. 17-0307.09

Expiration Date:

Approval Date:

E - 1

CGI Windows & Doors

NOTICE OF ACCEPTANCE: EVIDENCE SUBMITTED

A. DRAWINGS 1. Manufacturer's die drawings and sections.

(Submitted under previous NOA’s# 08-0530.01 and 09-1209.04)

2. Drawing No. W08–21, titled “Series 560 Alum Sliding Glass Door – SMI”, sheets 1 through

13 of 13, including sheets 2.1 and 9.1, dated 05/23/08, prepared by Al–Farooq Corporation,

with latest revised “G” dated 12/21/15, signed and sealed by Javad Ahmad, P. E.

B. TESTS 1. Test reports on: 1) Air Infiltration Test, per FBC, TAS 202–94

2) Uniform Static Air Pressure Test, Loading per FBC TAS 202–94

3) Water Resistance Test, per FBC, TAS 202–94

4) Small Missile Impact Test per FBC, TAS 201–94

5) Large Missile Impact Test per FBC, TAS 201–94

6) Cyclic Wind Pressure Loading per FBC, TAS 203–94

7) Forced Entry Test, per FBC, TAS 202–94

along with marked–up drawings and installation diagram of an aluminum SGD,

prepared by Hurricane Test Laboratory, Inc., Test Report No. HTL–0080–0707–09,

dated 11/10/09, signed and sealed by Vinu J. Abraham, P. E.

(Submitted under previous NOA No. 09–1209.04)

2. Test reports on: 1) Air Infiltration Test, per FBC, TAS 202–94

2) Uniform Static Air Pressure Test, Loading per FBC TAS 202–94

3) Water Resistance Test, per FBC, TAS 202–94

4) Large Missile Impact Test per FBC, TAS 201–94

5) Small Missile Impact Test per FBC, TAS 201–94

6) Cyclic Wind Pressure Loading per FBC, TAS 203–94

7) Forced Entry Test, per FBC, TAS 202–94

along with marked–up drawings and installation diagram of an aluminum SGD,

prepared by Hurricane Engineering Testing, Inc., Test Reports No.’s HETI–08–2070

dated 02/29/08 and revised on 05/21/08, HETI–07–4427 dated 12/27/07, HETI–07–

4405 dated 12/27/07 and revised on 04/08/08, and HETI–07–4418 dated 12/27/07, all

signed and sealed by Candido F. Font, P. E.

(Submitted under previous NOA No. 08–0530.01)

C. CALCULATIONS 1. Anchor verification calculations and structural analysis, complying with FBC-2014,

5th edition, dated 12/10/15, prepared by Al Farooq Corporation, signed and sealed by

Javad Ahmad, P.E.

(Submitted under previous NOA No. 15-0302.07) 2. Glazing complies with ASTM E1300-09

NOA No. 17-0307.09

Expiration Date:

Approval Date:

E - 2

CGI Windows & Doors

NOTICE OF ACCEPTANCE: EVIDENCE SUBMITTED

D. QUALITY ASSURANCE

1. Miami-Dade Department of Regulatory and Economic Resources (RER)

E. MATERIAL CERTIFICATIONS

1. Notice of Acceptance No. 15-1201.11 issued to Eastman Chemical Company (MA)

for their “Saflex Clear and Color Glass Interlayers” dated 03/07/16, expiring on

05/21/2021.

2. Notice of Acceptance No. 16-1117.01 issued to Kuraray America, Inc. for their

“Trosifol® Ultraclear, Clear and Color PVB Glass Interlayers” dated 01/19/17,

expiring on 07/08/19.

F. STATEMENTS

1. Statement letter of no financial interest, conformance and compliance with the

FBC–2014, 5th edition, dated 02/25/15, signed and sealed by Javad Ahmad, P. E.

(Submitted under previous NOA No. 15-0302.07) 2. Letter of Adoption of as his Own, the Work of another Engineer per Section 61G15–

27 of the FBPE, dated 03/03/10, signed and sealed by Javad Ahmad, P. E.

(Submitted under NOA No. 09–1209.04) 3. Proposal No. 08–1653 issued by Product Control, dated 01/28/09, approved and

signed by Ishaq Chanda, P. E.

(Submitted under NOA No. 09–1209.04) 4. Laboratory compliance letter prepared by Hurricane Test Laboratory, Inc., Test Report

No. HTL–0080–0707–09, dated 11/10/09, signed and sealed by Vinu J. Abraham, P.

E.

(Submitted under previous NOA No. 09–1209.04)

5. Proposals No.’s 07–3001–R and 07–3001–R–1 issued by Product Control, dated

10/23/07 and 01/10/08, both approved and signed by Ishaq Chanda, P. E.

(Submitted under NOA No. 08–0530.01) 6. Laboratory compliance letters prepared by Hurricane Engineering Testing, Inc., Test

Reports No.’s HETI–08–2070, HETI–07–4427, HETI–07–4405, and HETI–07–

4418 dated 02/29/08, signed and sealed by Candido F. Font, P. E.

(Submitted under previous NOA No. 08–0530.01)

7. One year extension request letter issued by CGI Windows and Doors, Inc., dated

05/30/17, signed by Robert Beaird, P.E.

8. Proposal No. 16-1527 issued by Product Control, dated 12/22/16, signed by Jorge

Plasencia, P. E.

9. Testing notification letter issued by Fenestration Testing Laboratory Inc., dated

03/30/17, and signed by Leigh Sanchez.

NOA No. 17-0307.09

Expiration Date:

Approval Date:

E - 3

CGI Windows & Doors

NOTICE OF ACCEPTANCE: EVIDENCE SUBMITTED

G. OTHERS

1. Notice of Acceptance No. 15-0302.07, issued to CGI Windows & Doors, for their

Series “560 Alum Sliding Glass Door – S.M.I.”, approved on 01/07/16 and expiring

on 06/26/17.