p1p1 application since sp-030 has illumination capabilities, its applications are more varied it is...
TRANSCRIPT
P1
Application• Since SP-030 has
illumination capabilities, its applications are more varied
• It is more suited for installation at wharfs, on top of concrete bollards, and anywhere where lighting is necessary, but wiring is an issue.
P2
P3
Operation • METEOR Bollards will operate at
least 12 hours per day and require at least 6 hours of direct sunlight recharge.
• Under extreme weather conditions, METEOR Bollards can operate for up to 3-4 days without recharging.
• With an average 5-6 year lifespan (up to 10 years in the lab), the Li-Fe battery can be replaced easily during maintenance.
For SP-010, 4 hour charging can last for 12 hour illumination., and fully charged Last 6 rainy days
P5
Installation • Installing wired lights
often cost the same, if not more, than the lights themselves.
• Meteor solves this time consuming and costly installation process with it s no-wiring design.
P6
Ultracapacitor & Battery
Hybrid Battery
For our new bollards, we incorporate Li-Fe batteries which are not only more efficient but with higher capacity
SANYO eneloop batteries
SANYO eneloop batteries are the first to combine the environmental and cost saving benefits of rechargeable batteries
Ultracapacitor
Ultracapacitors were previously featured in our paver and ground lights due to their long lifespan.
Battery Solution
P7
Power Management • With precise power management capabilities, Meteor
will equip future bollard designs with microcontrollers (MCU) to serve performance-critical roles.
• MCUs are also ideal for
– Increasing efficiency of solar power – Increasing LED illumination efficiency
– Extending battery life
LED Light Distribution ControlLED Light Distribution Control
LED Chip
Meteor customized lens
LED base
Meteor controls LED beam spread using the following methods:
1. LED base- reflective angle control
2. Customized lens design
LED base reflective angle
Before and After
First version Final version
P
Lumen : 9 lmLuminance: 12 lux (average)
Lumen : 16.5 lmLuminance: 21 lux (average)
P11
Finish • Fluoropolymer coating is
widely used in building exteriors, steel structures, aluminum surfaces, petrochemicals pipelines and vessels.
• Excellent long lasting performance, 10-20 years.
• Available in Dark Bronze, Black and Platinum Silver
P
Comparison of Batteries Comparison of Batteries
Lead-Acid Ni-Cd Ni-MH Li-Co LiFeP04 eneloop
batteries
Energy Density(Wh/Kg) 30 57 80 167 112 95
Cycle life 400 500 500 >500 >2000 >1500
Working Life(Yr) 1 2 2 2 5.5 4
Energy Efficiency (%) 60 75 70 90 95 80
Self-discharging (%) 20 30 35 10 8 10
Safety Average Good Good Worst Good Good
High Temperature Limitation
140 F 167 F 167 F 149 F 167F 167F
Green Product No No Yes Yes Yes Yes
P13
Applications Meteor's solar solution enables bollard lights to be installed and used in off grid areas where marking walkways is important but impractical or inconvenient using normal installation methods.
Campuses
Driveways
Walkways
Streetscapes
Gardens
Landscaping
Plazas
Entrances
Malls
Sidewalks
Courtyards
Building facades
P14
New Products Solar Illuminating Bollard Series - Designed for effective lighting of pathways, driveways, etc.
Features: - High-power LEDs provide a wide asymmetric distribution - No light above ninety degrees horizontal - Bollard housing and shaft are single- piece aluminum finished in fluoropolymer coating
P15
Meteor' s Design Roadmap
Solar Paver/Ground Light Solar LED Bollard /Post Light Solar Site / Area Light
P19Japan
P20Japan
SH-110 & SH-140Solar Paver Lights
“without” Solar Panels
June 2011June 2011
P29
Rimmer Consulting Group21438 N 38th PlacePhoenix, AZ 85050Phone/Fax 480-629-8894www.rimmerlighting.com
Thank you for your attention.