parts contents - e-glide
TRANSCRIPT
CONTENTS
1
1. Product and Parts .........................................
2. Basic Operation ............................................
3. Assembly Instructions .................................
4. Charging Instructions ................................
5. Riding Safety ......................................................
6. Scooter Maintenance ................................
7. Folding and Carrying.......................................
8. Warranty Information .....................................
9. Specifications .....................................................
Extension nozzle
Screw x 4
Hex wrench
Charger
PARTS
SCOOTER
PRODUCT AND PARTS
1
2
4
5
6
7
9
11
13
BASIC OPERATION
2 3
Headlight
Shows current speed
Dual drive
1. To turn on long press( 2 seconds)
Switch drive mode
Switch between Level 1 and Level 2
Level 1L evel 2
Front wheel drive Rear wheel drive(FWD)
(FWD)( RWD)
(RWD)
Rear wheel
Headlight
Speed
Dual Drive
Charging port Kickstand
Brake light
Disc Brake
Buckle
Front wheel
Folding buckle
Folding hook
Control panel
USB Charging port
Headlight
Brake handle
Handle
Pedal
4 5
ASSEMBLY INSTRUCTIONS CHARGING INSTRUCTIONS1 Secure the steerer tube and flick the kickstand down
3 Use the hex wrench to lock the screws on both sides
2 Install the handlebar
4 Turn on the scooter using theon/off button to test for power.
1 open the rubber plug
2 Insert the charging plug, when light on chargerturns from red to green the scooter is fully charged.
3 Tighten the rubber plug after charging finished.
RIDING SAFETY SCOOTER MAINTENANCERiding electric scooters is dangerous. Always wear safety gear such as a helmet and knee / elbow pads when riding. Obey the laws in your area and be courteous to other road users and pedestrians.
1 Do not ride in the rain, or on wet surfaces. It is dangerous and water ingress can damage the scooter.2 Electric scooters are designed to only be ridden by one person at a time.
CAUTION
1 Use a soft cloth to clean the scooter. Do not use a hose and avoid getting the scooter wet during cleaning. Water ingress will damage the electrics.2 Do not use alcohol, gasoline, kerosene or other corrosive chemical solution to clean.3 When not in use, store the scooter in a cool dry place.4 Do not store the scooter in direct sunlight, or outdoors where rain or other weather conditions could damage the scooter.
1 Do not install any other battery than that supplied by the manufacturer.2 Do not dismantle or puncture the battery.3 Use only the original charger for charging the scooter.4 After each use, fully charge the scooter to prolong the life of the battery.5 Do not expose the battery to temperatures higher than 50C or lower than -20C6 If storing for longer than 30 days, fully charge the battery first. When in storage the battery must be fully charged every 60 days.
Cleaning and Storage
Battery Maintenance
6 7
8 9
2 Stand on the pedal with one foot, and push the other foot backward
1 Check the battery indicator
4 To slow down, you can release the accelerator/throttle. For emergency braking, the front brake handle of the left handlebar shall be firmly grasped.
3 When the electric scooter slides, move your other foot on the pedal and stay steady. Then gently hit the throttle (at than 3km/h speed)
5 When turning, lean the body slightly towards that direction, and slowly turn the handle.
FOLDING AND CARRYINGFOLD:
OPEN:
First, make sure the power is off. Second, Hold the tube when open the folding button, then find the position of folding hook, and fix the folding hook to the rear fender.
When opening, first press the folding hook, Then hold the steerer tube and lock the folding button .
CARRYING:
Please note: Do not carry by handling the rear mudguard
After folding, carry with one or both hands by holding the tube
11
WARRANTY INFORMATIONFor any faults or issues you may experience with the G10X electric scooter, please contact the retailer where you purchased the scooter to have it assessed for warranty.
The warranty will be null and void if1 Damage is caused by failure to regularly service or maintain the scooter. (eg: tyres, brakes etc.)2 Damage is caused by misuse, traffic accidents or collisions.3 Damage is caused by environmental factors such as rain or excessive sunlight.4 Damage is caused by riding on rough, uneven surfaces or from performing stunts such as jumping the scooter.5 The scooter has been modified in any way or tampered with by a non authorised repairer.6 The scooter or battery is in any way damaged through malice or rough intent.7 The battery has overheated or been stored at a temperature above or below the recommended parameters.8 There is any sign of water ingress into any part of the scooter.9 Damage to the scooter caused by natural disaster or irresistible force.
Proof of purchase is required for any warranty claim. All warranties should go through the retailer where you purchased the product. For further information on the e-Glide warranty and product care, please visit www.e-glide.com.au/warranty
Tyres, brake pads, handlebar grips and plastic decorative covers are not covered by any warranty.
10
User information
Name:
Contact number:
Email:
Address:
Product information
Model:
Repair station:
Date of return:
Fault description:
Fault cause:
GUARANTEE CARD
START DATE OF WARRANTY EXTENSION
START DATE OF WARRANTY EXTENSION
START DATE OF WARRANTY EXTENSION
(DD/MM/YY)
(DD/MM/YY)
(DD/MM/YY)
12
SPECIFICATIONS
13
L x W x H (mm)Dimensions
Specifications
Weight
Target audience
Main Specs
1130 x 500 x 1150mm
Folded L x W x H (mm) 1130 x 500 x 480mm
Product Weight (kg) 14kg
Max Load 120kg
Age Range 16 - 50 Years
Height 120 - 200cm Tall
Max Speed 25km/h
Range 30km
Max Gradient 15°
Suitable Terrain
Working Temp. -10 - 40
Storage Temp. -20 - 45
Water Resistance IP54
36V
42V
Capacity (WH) 350
management system Over Current / Double Over Discharge Protection
Charger
Rated Current (A) 1.5
CCC, ROHS
Charging time (h) Approx 5 hours
Rated Power 350W
Max Power 550W
Rated Power 71
100 - 240V ~
42
Motor