Setting up your Perfect Walker is very simple and best done by following these easy instructions. You will be using your walker in a few minutes. It is recommended that you lay out all of the provided components and tools to ensure that you have easy access to them at each step.

PERFECT WALKERUNBOX & SET-UP GUIDE

INTRODUCTION

PERFECT WALKER UNBOX & SET-UP GUIDE2

Unpack the Perfect Walker and lay out the parts for easy access.

STEP 1

STEP 2

STEP 3

STEP 4

Loosen and remove the 4 large thumbwheel screws from the black lower frame.

Fold out each of the 4 wheel/leg combinations to their full positions, ensuring that the screw holes are lined up between the frame and the legs.

Insert the 4 thumbwheel screws that were removed in Step 2 into the 4 holes in the lower legs. The thumbwheel screws are to be inserted from the exterior side of the frame. The bolts may be a little tight when inserting into the holes - this is normal. Once inserted as far as they can go, screw them into place and lock the wheels into place.

Thumbwheel(x4)

Unfold the Perfect Walker so that the seat is locked into place. Push firmly down on both sides of the seat until you hear the seat click into its locked position. It will look like the image below when locked into place.

STEP 5

PERFECT WALKER UNBOX & SET-UP GUIDE 3

Insert the upper arms (identified with the push pins on one side of each arm) into the right and left posts. The proper position for each is with the push pins to the outside and the thumbwheel below the arm cuffs facing forward.

The push pins on each arm are the way to adjust the arms for an appropriate height. This can be done as a last step.

Insert the handles into the front of the arm tubes. You may need to loosen the thumbwheels under the arms to allow the handles to be properly inserted into the arm supports. These are adjustable. Once you have determined the appropriate length, lock the handles into place by firmly tightening the thumbwheels in the upper arms.

At this step, check all thumbwheels for tightness and that the seat is locked firmly into place. This ensures that the frame of the walker will remain open during use as well as when sitting in the seat.

STEP 6

STEP 7

STEP 8

Your fully assembled Perfect Walker will look like this…the storage bag under the seat attaches to the posts in front of the seat using the loops on either side of the bag.

The Perfect Walker is now ready for use. Please use it only in accordance with its intended use as a device to assist walking. Please note that the specified user weight may not exceed 300 pounds and it will only hold one user at a time, particularly when seated on the walker’s seat.

FULLY ASSEMBLED PERFECT WALKER

If you have ANY questions, please don’t hesitate to ask - you can contact our Customer Service Agents Monday through Friday between 9am and 8pm eastern time.

Our toll free number is 800-958-8324.

CUSTOMER SUPPORT

PERFECT WALKER UNBOX & SET-UP GUIDE