(PII series)

EX

MO

TOR

MO

TOR

1

12

4

3

4

2

3

TORMO

TORMO

MOTOR

20201080201

Double-check the motor and gearbox size.Clean the mounting surfaces.

Rotate the set collar until the bolt hole is aligned with access hole.

Tighten the mounting bolts in 1~4 order withtorque wrench to specified torque (See Table1) Insert the plug

Set at vertical position. Tighten the mounting bolts (including washer) in 1~4 order with wrench to 5% specified torque. (See Table 1)

Tighten the set collar bolt with torque wrenchto specified torque. (See Table 2)

a. Remove motor key, if necessary.b. Insert balance key, if necessary.

Check motor shaft size. (If necessary, please insert bush)When installing on keyed or flatted

shafts, please refer to figure below.

Correct installation.

Note: Tightening Torque values can be exceeded by 20% for increased clamping force.

[mm] [mm] [mm] [Nm] [In-lbs]

PE II 050 PA II 042PG II 040 PN II 017PS II A

PE II 070 PA II 060 PG II 060 PN II 023 PS II B

PE II 090 PA II 090 PG II 080 PN II 034 PS II C

PE II 120 PA II 115 PG II 120 PN II 042 PS II D

PE II 155 PA II 142 PG II 160 PN II 056 PS II E

C3≦8C3≦11C3≦14C3≦8C3≦11C3≦14C3≦19C3≦14C3≦19C3≦24C3≦28C3≦19C3≦24C3≦28C3≦32C3≦35C3≦38C3≦19C3≦24C3≦28C3≦32C3≦35C3≦38C3≦42

4444446466666688866688810

9.89.89.89.89.89.8419.8414141414141808080414141808080139

878787878787364873643643643643643647097097093643643647097097091232

M5 x 0.8P x 16LM5 x 0.8P x 16LM5 x 0.8P x 16LM5 x 0.8P x 16LM5 x 0.8P x 16LM5 x 0.8P x 16LM8 x 1.25P x 25LM5 x 0.8P x 16LM8 x 1.25P x 25LM8 x 1.25P x 25LM8 x 1.25P x 25LM8 x 1.25P x 25LM8 x 1.25P x 25LM8 x 1.25P x 25LM10 x 1.5P x 30LM10 x 1.5P x 30LM10 x 1.5P x 30LM8 x 1.25P x 25LM8 x 1.25P x 25LM8 x 1.25P x 25LM10 x 1.5P x 30LM10 x 1.5P x 30LM10 x 1.5P x 30LM12 x 1.75P x 35L

APEX-2014-12-1 E

886-4-24650219 886-4-24650118

40763