powershred 99ci the world’s toughest shredders · 2018. 1. 30. · 2 capabilities english model...
TRANSCRIPT
PLEASE READ THESE INSTRUCTIONS BEFORE USE.DO NOT DISCARD: KEEP FOR FUTURE REFERENCE.
VEUILLEZ LIRE CES INSTRUCTIONS AVANT D’UTILISER L’APPAREIL. NE PAS JETER : CONSERVER AFI N DE CONSULTER LES DIRECTIVES ULTÉRI-EUREMENT, EN CAS DE BESOIN.
LEA ESTAS INSTRUCCIONES ANTES DEL USO.NO LAS DESECHE: CONSÉRVELAS COMO REFERENCIA FUTURA.
Powershred® 99Ci The World’s Toughest Shredders®
2
CAPABILITIES
ENGLISHModel 99Ci
KEYA. SafeSense® TechnologyB. Paper entryC. See safety instructionsD. CD/Card safety flapE. Pullout binF. CastersG. Disconnect power switch 1. OFF 2. ON
H. Control Panel and LEDs 1. Overheat (red) 2. Bin open (red) 3. Bin full (red) 4. Remove Paper (red) 5. SafeSense® indicator (yellow)
6. Reverse 7. ON/OFF (blue) 8. Forward
IMPORTANT SAFETY INSTRUCTIONS — Read Before Using!
manual. Read the entire instruction manual before operating shredders.
set to off or unplug when not in use.
) to back out
shredder. DO NOT USE “CANNED AIR” OR “AIR DUSTERS” ON SHREDDER. Vapors from propellants and petroleum based lubricants may combust causing
Do not place near or over heat source or water.
position. This action will stop shredder immediately.
voltage and amperage designated on the label. The grounded outlet or socket
Warning: NOTE:
harmful interference to radio communications.
A.B.
D.
C.
G.
F.
E.
H.
Will shred:Will not shred:
Paper shred size: ...............................................................................
Maximum: Sheets per pass ........................................................................................................... 18* CDs/Cards per pass ....................................................................................................... 1* Paper entry width .............................................................................................9”/230mm
10 CDs. 18 sheets per pass.
Fellowes SafeSense® shredders are designed to be operated in home and office environments ranging
BASIC SET UPCASTER INSTALLATION
118
2 3 4 5
BASIC SHREDDING OPERATION
Continuous operation:
NOTE: Shredder runs briefly after each pass to clear entry. Continuous operation beyond
3
ADVANCED PRODUCT FEATURES
Press ( ) ON to activate (blue)
PAPER OR CD/CARD
Feed paper straight into paper entry and release
Plug in and put disconnect power switch in ON (I) position
When finished shredding set to OFF ( )
SilentShred™ Technology
shreds without noisy disruptions.
Patented SafeSense® Technology Stops shredding immediately when hands touch the paper opening.
Jam Proof System
18
18
18
43 521 21 6or
To shred CDs or credit cards rotate safety flap into place
Hold card/CD at edge. Feed into center of entry and release
*100% Jam Proof when used in accordance with user manual
Remove several sheets untilindicator is below red.
Proof Shredding
If a misfeed If illuminates after paper has been
1 2 3
sheets have been inserted.
can be added.
All indicators light up and Wait for flashing to stop after automatic correction is complete. Regular shredding will resume.
SAFESENSE® TECHNOLOGY OPERATIONStops shredding immediately when hands touch the paper opening.
or
SET-UP AND TESTING
Turn the shredder ON ( ) to activate SafeSense®
Touch test area and look for the SafeSense® indicator to illuminate
SafeSense® is active and working properly
If hand is held on SafeSense®
area more than 3 seconds shredder will shut off
WHEN IN SLEEP MODE
In sleep mode To get out of sleep mode touch control panel
insert paper
For more information about all of Fellowes Advanced Product Features go to www.fellowes.com
ENERGY SAVINGS SYSTEM
standby mode and sleep mode.
1818 18
3
18
18
1 3
2 421
22
JAM PROOF SYSTEM OPERATION*
ENGLISHModel 99Ci
Press and hold forward ( )
2
4
PRODUCT MAINTENANCE
CLEANING AUTO-START INFRARED SENSORS
may become blocked by paper dust causing the motor to run even if there is no paper present. .
recommend you oil your shredder each time you empty your waste bin.
OILING SHREDDER
*Only use a non-aerosol vegetable oil in long nozzle container such as Fellowes 35250
FOLLOW OILING PROCEDURE BELOW AND REPEAT TWICE
*Apply oil across entry
18
1
TO CLEAN THE SENSORS
1
Turn off and unplug shredder infared sensor
Dip cotton swab in rubbing alcohol away any contamination
from the paper sensors
18
43182
TROUBLESHOOTING
will remain illuminated and the shredder will not operate for the duration of the recovery time. See Basic Shredding Operation for more information about the continuous operation and recovery time for this shredder.
SafeSense® ® indicator will illuminate and the shredder will stop shredding. If SafeSense®
5
LIMITED PRODUCT WARRANTY
defects in material and workmanship and provides service and support for 2 years from the date of purchase by the original consumer. Fellowes warrants the cutting blades of the machine to be free from defects in material and workmanship for the lifetime of the shredder. If any part is
repair. Fellowes reserves the right to charge the consumers for any additional costs incurred by
Fellowes to provide parts or services outside of the country where the shredder is initially sold
or incidental damages attributable to this product. This warranty gives you specific legal rights.
6
CAPACITÉS
FRANÇAIS Modèle 99Ci
CONFIGURATION DE BASEINSTALLATION DES ROULETTES
TOUCHEA. Technologie SafeSenseMD
B. Entrée de papier
de sécuritéD. Rabat de sécurité CD/CarteE. Contenant amovibleF. RoulettesG. Sectionneur 1. ARRÊT 2. MARCHE
H. Panneau de commande et DEL 1. Surchauffe (rouge) 2. Contenant ouvert 3. Contenant plein (rouge)
5. Voyant SafeSenseMD
6. Inversion 7. MARCHE/ARRÊT (bleu) 8. Marche avant
AVERTISSEMENT :
sérieuses blessures.
ce produit.
piles ou puces sonores
IMPORTANTES INSTRUCTIONS DE SÉCURITÉ — À lire avant d’utiliser !
A.B.
D.
C.
G.
F.
E.
H.
Déchiquettera :trombones
Ne déchiquettera pas :
Taille de déchiquetage du papier : Coupe croisée ...................................................................
Maximum : Feuilles par passage .................................................................................................... 18* CD/cartes par passage .................................................................................................. 1*
...........................................................................230 mm/9 po
18 feuilles par passage.
MD
118
2 3 4 5
7
CONFIGURATION ET TEST
MARCHE ( ) pour activer (bleu) de CD pour le mettre
en place
directement dans
aller
sectionneur en position MARCHE (I)
Opération en continu :
REMARQUE : La
déclenchera une période de refroidissement de 40 minutes.
)
OPÉRATION DE DÉCHIQUETAGE DE BASE
PAPER OR CD/CARD
FONCTIONS AVANCÉES DE LA DÉCHIQUETEUSE
18
18
18
43 521 21 6ou
Système à l'épreuve des blocages
Technologie SafeSenseMD brevetée
du papier
Technologie SilentShredMC MC
interruption bruyante
*100 % à l’épreuve des blocages lorsque utilisé conformément au manuel de l’utilisateur
1 2 3
ont été insérées.
plus de feuilles.
est optimisée.
Si
voyant soit sous rouge.
SYSTÈME À L’ÉPREUVE DES BLOCAGES*
ousur la section SafeSense® pendant plus de 3
s éteindraEn mode veille Pour sortir du panneau
de contrôle tactile en mode veille
insérer le papier
SYSTÈME D’ÉCONOMIE D’ÉNERGIEservice et hors service).
1818 18
3
18
18
1 3
2 421
22
OPÉRATION DE TECHNOLOGIE SAFESENSEMD
La fonction SafeSenseMD est activée et fonctionne correctementvoyant de la fonction
SafeSenseMD
MARCHE ( ) pour activer la fonction SafeSenseMD
Pour de plus amples informations sur les fonctions avancées des produits Fellowes, visitez www.fellowes.com
EN MODE VEILLE (SLEEP)
18
8
FRANÇAIS Modèle 99Ci
NETTOYAGE DES CAPTEURS INFRAROUGE DE DÉMARRAGE AUTOMATIQUE
MAINTENANCE DE BASE
HUILAGE DU DESTRUCTEUR
Eteindre et débrancher le destructeur
Repérer le capteur infrarouge de démarrage
Nettoyer toutes les saletés des capteurs de papier avec le
Appuyer et maintenir enfoncée la touche Avancer ( ) pendant
POUR NETTOYER LES CAPTEURSSUIVRE LA PROCEDURE D’HUILAGE CI-DESSOUS ET LA REPETER DEUX FOIS
ATTENTION
118
432
* N’utiliser que de l’huile végétale dans un conteneur à long col sans aérosol telle que l’huile Fellowes n° 35250.
218
1
DÉPANNAGE
récupération pour ce broyeur.
Voyant SafeSenseMD MD MD est
9
GARANTIE LIMITÉE DU PRODUIT
CAPACIDADES
ESPAÑOL Modelo 99Ci
CONFIGURACIÓN BÁSICA
10
INSTALACIÓN DE LAS RUEDITAS
EXPLICACIÓNA. Tecnología SafeSense®
B. Entrada del papelC. Consulte las instrucciones
de seguridadD. Tapa de seguridad para
F. Rueditas
de la energía 1. APAGADO 2. .ENCENDIDO
H. Panel de control e indicadores luminosos
5. Indicador de SafeSense
(amarillo)
6. Retroceso 7. ENCENDIDO/APAGADO 8. Avance
INSTRUCCIONES DE SEGURIDAD IMPORTANTES ¡Léalas antes de usar la máquina!ADVERTENCIA:
manual de instrucciones. Lea dicho manual en su totalidad antes de operar las trituradoras.
desenchufe la trituradora cuando no esté en uso.
lesiones graves.
calor o agua.
trituradora.
prolongadores.
sonido o baterías.
A.B.
D.
C.
G.
F.
E.
H.
Destruye:No destruye:
Tamaño de corte del papel: .......................................................................
Máximo: ......................................................................................................... 18*
................................................................................................ 1* Ancho de la entrada de papel ........................................................................230 mm (9”)
Las destructoras SafeSense®
118
2 3 4 5
OPERACIÓN BÁSICAS DE LA DESTRUCTORA
ENCENDIDO ( ) para
PAPEL O CD/TARJETA
directamente en la entrada de papel y suelte
el interruptor de
ENCENDIDO (I)
Funcionamiento continuo:
NOTA: la destructora funciona brevemente después de cada pasada para limpiar la entrada. El funcionamiento
enfriamiento de 40 minutos.
Cuando termine de
de APAGADO ( )
11
CARACTERÍSTICAS AVANZADAS DEL PRODUCTO
18
18
18
43 521 21 6o
Sistema a prueba de atascos Elimina los atascos de papeles y
Tecnología SafeSense® patentada
cuando las manos tocan la abertura para papel
Tecnología SilentShred™ La calidad sonora SilentShred™ destruye sin hacer ruidos molestos.
Para destruir CD o CD sobre el borde.
entrada y suelte
*Es 100% a prueba de atascos cuando se utiliza según el manual del usuario
Si se produce una
1 2 3
una pausa de 3 a 6 segundos
OPERACIÓN DEL SISTEMA A PRUEBA DE ATASCOS*Elimina los atascos de papeles y supera los trabajos.
o
SafeSense®
1818 18
3
18
18
1 3
2 421
22
TECNOLOGÍA SAFESENSE® manos tocan la abertura para papel.
SafeSense®
activa y funciona correctamente
prueba y espere a
SafeSense® se encienda
Encienda ( ) la destructora para activar SafeSense®
Si desea obtener más información acerca de todas las características avanzadas del producto de Fellowes, visite www.fellowes.com
CONFIGURACIÓN Y PRUEBA
En modo latente inserte papel
CARACTERÍSTICAS DEL MODO LATENTE
SISTEMA DE AHORRO DE ENERGÍA uso y fuera de uso.
18
12
ESPAÑOL Modelo 99Ci
MANTENIMIENTO DEL PRODUCTO
PARA LIMPIAR LOS SENSORES
ENGRASE DE LA DESTRUCTORA
PRECAUCIÓN
REALICE EL SIGUIENTE PROCEDIMIENTO DE ENGRASE Y REPÍTALO DOS VECES
la entradaMantenga pulsada la tecla ( ) de retroceso (2 a 3 segundos)
LIMPIEZA DE LOS SENSORES INFRARROJOS DE INICIO AUTOMÁTICO
el motor siga funcionando aún cuando no haya papel.
Localice el sensor de Impregne un bastoncillo de de los sensores de
papel con el bastoncillo
Apague y desenchufe la destructora
118
432
* Use sólo aceite vegetal que no sea en aerosol en los contenedores de boquilla larga como el Fellowes No. 35250
218
1
SOLUCIÓN DE PROBLEMAS
Indicador SafeSense® ® ®
13
GARANTÍA LIMITADA DEL PRODUCTO
libres de defectos de material y mano de obra y proporciona servicio y soporte técnico durante
1789 Norwood Avenue, Itasca, Illinois 60143 1-800-955-0959 www.fellowes.comB r a nd s
© 2017 Fellowes, Inc. | Part #410007
United States: 1-800-955-0959Canada: 1-800-665-4339Mexico: 001-800-514-9057
CUSTOMER SERVICE & SUPPORTwww.fellowes.com