Properties of Water

Read information about the properties of water and carry out the experiments using the materials at your lab station.

Answer all the questions on the worksheet provided as you go through this PowerPoint & complete all experiments.

Directions

Part I: Structure of WaterAnswer all questions on your worksheet.

Structure of Water

This is the structural formula of water.

A. Draw a picture of water.

B. What is the chemical formula of water?

(–) (–)

(+) (+)

O

HH

Structure of Water

• The Hydrogen and Oxygen in water are bonded covalently.

• HINT: definition of covalent!

D. Why does oxygen form 2 bonds and hydrogen forms one bond?

(–) (–)

(+) (+)

O

HH

Structure of Water

However, as the atoms share their electrons they do not do so evenly.

E. Which atom is larger? O or H?

The oxygen in water hogs the electrons and is therefore slightly negative.

This results in the two hydrogen atoms becoming slightly positive.

F. Add the + and – charges to your picture in A.

(–) (–)

(+) (+)

O

HH

Structure of Water

Water is POLAR. Hint: what is polarity?

Polarity contributes to emergent properties of water

(–) (–)

(+) (+)

O

HH

Batteries have a + and – pole!

Earth has a north and south pole!

G. What is polarity?H. Why is water considered polar?

Hydrogen bond(+)

(+)

H

H(+)

(+)

(–)

(–)

(–)

(–)

O

Hydrogen Bonds

One water molecule tends to bond to another water molecule by hydrogen bonding. The H+ on one molecule is

attracted to the O- of another.

Each water molecule can form a max. of 4 hydrogen bonds with 4 other water molecules

A single hydrogen bond is weaker than a single covalent bond. However, groups of hydrogen bonds are very strong

Responsible for the “stickiness” of water molecules

I. Why do hydrogen bonds form between water molecules?J. Draw 4 water molecules connected by hydrogen bonds.

STOP!

Review as a class

Polarity video

Review as a class

Part III: Specific HeatWrite this heading on your paper and then answer all of the questions for this section

under that heading!

HIGH SPECIFIC HEAT - amount of heat a substance needs for a given increase of temperature

Takes a lot of energy to raise 1 g of water by 1° C because you must break Hydrogen bonds

So… Liquid H2O can absorb large amounts of heat with small changes in temperature

So… It heats up more slowly and retains heat longer than surroundings

This is important for many reason – for instance in organisms it helps us maintain a constant temperature (homeostasis)

Specific Heat

HIGH HEAT OF VAPORIZATION- Takes a lot of energy to convert liquid H2O into vapor (hydrogen bonding-restricts movement)

Vaporization (evaporation) is the change from liquid to gas; Molecules of liquid escape and enter air

Evaporation of water produces cooling effect

Again this is important for many reasons – for instance in some organisms sweat/pant to cool off when hot (evaporative cooling)

ACTIVITY Click this link and complete the exercise. Changing MatterA. As you do describe what happens to the water molecules as you melt the ice cube.

B. Why does the graph level off during freezing/melting and then again during condenses/boils?

C. What property of water makes it able to absorb a great deal of energy before it changes from solid to liquid to gas? (Hint: what has to break to release water molecules from each other?)

Water expands when it freezes (one of few substances that does this) SO . . . ICE IS LESS DENSE THAN LIQUID WATER

Hydrogen bonds keep molecules “at arm’s length” when freezing so ice floats  

Again this is important for many reasons – for instance it insulates bodies of water. Lakes freeze from top down; allowing living things to survive in winter when the lake freezes

This blue ice cube floats in water because ice is less dense than liquid water.

The blue ice cube sinks in alcohol because ice has a greater density than alcohol.

Water Alcohol

D. Describe the structure of ice vs. liquid water and explain why ice is less dense than water.See this link for help: Why does ice float?

STOP!

Review as a class

Part II: Cohesion and Adhesion

Answer all of the questions for this section under that heading!

COHESION Water molecules 'stick to each other' (due to

hydrogen bonding) Makes water act as if it has invisible “skin” Called SURFACE TENSION (how difficult it is

to break surface) A. Define cohesion

See the ‘skin’ of the water AKA surface tension!

ACTIVITY: How much water can one penny hold?

Fill the top of a penny with water until a clear bubble has formed on top but it is NOT overflowing.

Follow the directions stated on your handout!

ACTIVITY: Can you float a needle on the water drops on your penny?!Slower & softly place a needle on the water on top of the penny. Answer question 2 and 2a.

With your finger, spread one small drop of detergent on the surface of a dry penny.Fill the top of a penny again with water until a clear bubble has formed on top but it is NOT overflowing. Does the needle float?

3. Could this penny hold more, less or the same amount of water?

3a. Did the detergent make a difference? Describe the effect of the detergent.

Wax paper: Does the water roll or slide down a surface?

Complete the instructions on your handout.

 ADHESION- Water molecules stick to other substancesMakes water cling to the sides of a cylinder.F.  Define adhesion.

ACTIVITY: How many pennies can two microscope slide stuck together by water hold?

Follow the instructions on your handout.

Stack pennies Hold here

CAPILLARY ACTION Movement of liquid through a narrow passage

or substance Result of cohesion of water molecules to each

other and adhesion to another surface. Makes water ‘travel.’

STOP!

Review as a class

Part IV: Water is the Universal Solvent

Write this heading on your paper and then answer all of the questions for this section

under that heading!

Solution = liquid consisting of uniform mixture of two or more substances Two parts of a solution:

Solvent = liquid (dissolving agent) Solute = substance dissolved

(EX: Water = solvent; Koolaid powder/sugar = solutes; Kool-aid = solution)

To make a solution you need to remember the rule - “like dissolves like”

Since water is polar it will dissolve ions and polar substances

Since water is polar it will NOT dissolve anything nonpolar

Water is the ‘universal solvent’

Oil is an example of a nonpolar molecule. It does not form hydrogen bonds.

Like dissolves like, therefore, oil (nonpolar) does not dissolve in water (polar).

Nonpolar molecules are called hydrophobic or 'water hating’ because they do not mix with water.

Non polar molecules are hydrophobic

A. Briefly explain what a solution is and its parts.

B. You make instant coffee in the morning by adding a tablespoon of coffee to a hot cup of water. Label the solution, solute and solvent in this scenario.

C. Why doesn’t oil and water mix?

ACTIVITYUsing the pipettes provided add 2ml of water to a test tube.Gently add 2 ml of cooking oil to the same tube by tilting the test tube of water slightly and letting the oil run slowly down the inside of the test tube.D. Describe what happened.

ACTIVITYAdd a few drops of food coloring to each test tube. Place your finger over the test tube and gently shake to mix the oil and water. F. How does the food coloring act in each test tube? Does it mix into the oil? Into the water? G. Explain why water molecules and oil molecules separate from each other. Your explanation should discuss polar and non-polar molecules, and the effects of polarity on the interactions between water molecules, and hydrogen bonding.

If you have time watch this quick video to review the PPT. Make sure to use headphones!

http://www.youtube.com/watch_popup?v=Jh2qpsZe6GA#t=32

http://www.youtube.com/watch?v=DVCYlST6mYQ

Review

Can you define the Vocabulary?!

Polar bond Hydrogen bond Cohesion Surface tension Adhesion Specific heat

Density Solution Solvent Solute pH Acid Base