PWHAPI 610

SINGLE STAGE OH2

8885. Monroe St. Houston, Texas USA 77061 Phone: (713) 956-2002

Fax(713) 956-2141

STDS-PWH-IOM-TM-2.0 Page 3 of 35

Section 1 – PWH Pump Description

The PumpWorks 610 11th Edition Upgrade (PWH) is a bearing bracketed Horizontal Single Stage Centrifugal pump. It is manufactured in accordance with the American Petroleum Institute Standard 610. The PumpWorks 610 pump features short impeller overhang, and can be combined with single, double, and triple volute casings in various sizes. The back pull-out design, in most cases, allows the complete rotating assembly of the pump to be removed without removing or disrupting the driver as well as the suction and discharge piping.

Section 2 - Installation & Handling

Inspection Upon receipt, carefully inspect the pump for damage and check against the bill of lading. Report any damage or shortage to the carrier's local representative and send a copy to PumpWorks. When uncrating, be careful not to discard any small accessories that may be attached to the crate.

Handling Lift the complete unit using proper lifting techniques.

CAUTION: Lifting eyes may be provided on the casing cover. These are designed for lifting the casing cover only. Never lift the pump assembly using these lifting eyes. The pump assembly may not be balanced when lifting. Always provide proper support so that the pump cannot tip.

Storage - Short Term When it is necessary to store the pump for a short time (less than 6 months) before it can be installed, place it on a skid in a dry location. Protect it thoroughly from moisture, sand, grit and other contaminants. Do not remove the protective covers on the suction and discharge flanges.

Storage - Long Term More thorough precautions are required if the pump is to be stored for greater than 6 months. The pump must be covered or stored indoors. Prior to storage, remove the oil vent plug and fill the bearing housing with one quart of vapor emitting oil. Reinstall vent plug. Perform the following at 6 month intervals: