CONVERTING MAKESHIFT METHODS INTO ENGINEERED SOLUTIONSSM

QUICK STAND™ FLOOR-MOUNTED WATER HEATER/EQUIPMENT SUPPORT

•Protect your property and water supply

•Mount water heaters directly to the floor, in open areas

•Supports water heaters up to 100 gallons

•Certified to meet or exceed building code equipment anchorage requirements

•Third-party engineer certified

•Allows water heaters or equipment to be secured in top third and bottom third of unit

www.holdrite.com • (800) 321-0316

PROPERTYIN

TELLECTUAL

PATENTPENDING

HOLD-077_CutSheet-Update_03.indd 1 8/14/15 1:51 PM

CONVERTING MAKESHIFT METHODS INTO ENGINEERED SOLUTIONSSM

QUICK STAND™ FLOOR-MOUNTED WATER HEATER/EQUIPMENT SUPPORT

Anchorage of Non Structural Components Such as Water Heaters Non-structural components weighing greater than 400 pounds, subject to a few specific exemptions, require permanent anchorage. Therefore, water heaters 40 gallons or larger will typically require anchorage. Also, in some jurisdictions, code requires that even smaller units must be anchored. Check with your local jurisdiction with regards to equipment anchorage, or refer to ASCE 7-10 Chapter 13; 2013 CBC Sections 1613 and 1616A; and 2012 IBC Section 1613.

© 2015 HOLDRITE. All Rights Reserved. #LT73 2/15www.holdrite.com • (800) 321-0316

Model # Description Box Qty.20-FMWH-1* rated up to 75 gallons for 20” - 26” diameter tanks, 4 1/2” min slab 1

20-FMWH-1A* rated up to 60 gallons for 20” - 26” diameter tanks, 4” min slab 1

20-FMWH-2 rated up to 100 gallons for 26” - 32” diameter tanks, 4 1/2” min slab 1

*For water heaters/equipment less than 20” in diameter, drill or punch additional holes as necessary.

2.00 .75

81.4” (20” - 26” Dia. Tanks) or 100.2” (26” - 32” Dia. Tanks)

1.25 TYP 1.25 TYP

1.25

18X .265

Strap (2)

Braces (3)

Bracket (4)

3/8” Carriage Bolt (2)

3/8” Flat Washer (2)

3/8” Hex Nut (2)

3/8” Concrete Anchors (6)

©HOLDRITE 2015

HOLD-077_CutSheet-Update_03.indd 2 8/14/15 1:51 PM