> 1 m

> 2 m

Quick Start for Robomower

1

2

Placing the charging station

Remove all the obstacles on the grass field.

3

5 Programming

4

Main switch

Main switch locationCutting height adjustment

＜100 m2

10 Ω

A

C

E

J

A

I

A

B

A

Close the cover

C

D

A

Wire stripper10 - 15 mm

G

End point of theboundary wire

D

F

H

B

Press the start button

®

Set the boundary wirewith pegs.

The charging station must be positioned on relatively level ground.

Allow the straight boundary wire, at least 2m long with no obstacles to the front of the charging station.

The pegs and the boundary wireshould be as close as possible tothe ground to prevent tripping.

Start point ofthe boundarywire

Possible position of thecharging station

Be sure to select the same signal (S1 or S2) for the charging station and the Robomower.

When the working area is less than 100 m2 or total boundary wire less than 40 m, please integrate the supplied 10 Ω / 20 W cement resistance to the boundary wire.

1 meter of wire reserved forpossible adjustments

Always start in a high cutting position and work your way down to the cutting height you want.

Press the button 4 times to unlock the control panel.

Set the working time by press the button marked hours.

OK

NO

Never cross the wires.

> 2m

> 10 cm> 10 cm

< 5 mm

< 27°

> 40 cm

Boundary wire

< 8m

>2m

> 10 m

40 cm

80 cm

S1 S2> 0.5 m

> 10 m

Pegging your Boundary Wire®

If you prefer mowing robot totravel over the two parallelboundary wires, the gap distanceof wires above showed must beless than 5 mm. If the mowingrobot only runs in a circle inthe home mode, please puta post or obstacle at position A.

If the mowing robot is not to cross theboundary wire, the distance betweenthe two wires must be at least 10 cm.