R-96-1-18

IMPORTANT: Read all directions and cautions carefully before starting. WARNING: Denture reliner liquid is fl ammable. Keep away from heat, open fl ames or sparks. WARNING: Avoid getting denture reliner liquid on skin. If you do, wash area with water immediately. WARNING: Contains methacrylates. Do not use if you are allergic or sensitive to methacrylates. WARNING: Do not use on Valplast Dentures (fl exible dentures). WARNING: Do not inhale vapors from denture reliner liquid. Use in a well-ventilated area.

NOTE: After relining has been completed, if for any reason the denture is uncomfortable or does not fi t, do not use it. Remove the liner material and see your dentist immediately.

1 Clean and dry denture thoroughly.

2 Place one packet of powder and one packet of liquid into a freezer for 3 minutes.

3 Mix Reline-It® liquid and powder in one of the enclosed mixing cups as follows:

4 Allow the mixture to set for 30 seconds in the mixing tray. Mix thoroughly once again and then spread all the material onto the denture.

5 Allow the mixture to set for 3 minutes. Make sure that your gums and palate are moist and then place the denture into your mouth.

6 Bite down and hold the denture in the correct biting position for 6 minutes. A slight tingling sensation of the gums or palate may be experienced. NOTE: A small number of people may have a sensitivity to this product. If the tingling makes you feel uncomfortable, remove the denture immediately and remove the reline material from the denture. See your dentist for relining.

7 Take out of mouth and rinse with cold water.

8 Using the enclosed spatula trim off any excess material that overlapped denture.

9 Place denture in hot tap water and let set for 20 minutes. Then add 1 teaspoon of Baking Soda to1 cup of warm water and soak the denture for a further ten minutes to remove any taste.

10 Wash (rinse) denture again in cold water and trim any excess material from denture that was left behind the fi rst time.

11 Place denture back into mouth. (DONE)

12 Rinse off spatula and save to be used with second repair.

Do not use over an existing reline. Remove old reline first. WARNING:

a. Hold a Reline-It Liquid packet in one hand and gently tear off the notched end so as not tospill any of the liquid. Put all of the liquid into one of the enclosed mixing cups. Be carefulnot to get any Reline-It Liquid onto your skin. This liquid is flammable. Do not use nearsparks or an open flame. Use in a well-ventilated area.

b. Hold the end of a Reline-It Powder packet and shake it so that the powder goes to theother end. Rip off the end that you are holding and add all of the powder to the liquid inthe mixing cup.

c. Using the spatula, mix just until the mixture becomes smooth.

NOTE: How to remove Reline-It - Do not use any sharp or metal objects. Using your thumb, keep lifting from the underside edge of

the reline until enough is lifted where you can grab it with 2 fi ngers and peel it off gently. If you have diffi culty, call our offi ce for help.

WARNING: For temporary refi tting of dentures between dental visits. For best results, use up to one week per application. Improper or long term use of denture cushions, pads or reliners may lead to faster gum erosion, irritation and sores. For use only until a dentist can be seen.

Any problems or questions -call us at 833-362-2763M-F, 8:00 AM to 5:00 PM E.S.T.

or visit our web site at www.doc-brands.comKEEP OUT OF THE REACH OF CHILDREN© 2018 DOC Brands, Inc., Wayne, PA 19087

R-96-1-18 10/8/18 8:40 AM Page 1

Como remover Reline-It. No utilice objetos puntiagudos o metálicos. Usando su pulgar, siga levantando desde el borde inferior del rebasado hasta que haya suficiente material levantado donde se puede agarrar con 2 dedos y despegar suavemente. Si tiene dificultad, llame a nuestra oficina para ayuda.

R-96-1-18

No use sobre un rebase existente. Retire el rebase viejo primero.

a. Aguante un paquete de líquido de Reline-It en una mano y arranque suavemente elextremo con la muesca para no derramar el líquido. Ponga todo el líquido en una de lastazas de mezclar. Tenga cuidado de evitar que el líquido Rebasador de dentaduras lecaiga en la piel. Este líquido es inflamable. No lo use cerca de fuentes de chispas o dellamas abiertas. Úselo en una área buen ventilada.

b. Aguante el extremo de uno de los paquetes de polvo de Reline-It y agite para que elpolvo vaya al otro extremo. Arranque la esquina del paquete que estés aguantando ycoloque el contenido completo de polvo al líquido en la tazas de mezclar.

c. Utilice la espatula para revolver hast obtener una mezcla pareja.

Coloque un paquete de polvo y un paquete de líquido en el congelador durante 3 minutos.

Coloque la dentadura en agua caliente y deje reposar durante 20 minutos. A continuación, agregue1 cucharadita de bicarbonato de sodio a 1 taza de agua tibia y remoje la dentadura por otros diezminutos para eliminar cualquier sabor.

R-96-1-18 10-8-18 Page 2

En caso de que tenga cualquier problema o pregunta, llámenos al 833-362-2763,de lunes a viernes, entre las 8:00 am y las 5:00 pm, hora del este

o visite nuestro website en www.doc-brands.comMANTENGA FUERA DEL ALCANSE DE NIÑOS© 2018 DOC Brands, Inc., Wayne, PA 19087