WT:.:T:I WELDER TRAINING AND TESTING INSTITUTE

WWW.WTTI.COM 1144 N. GRAHAM ST. • ALLENTOWN, PA 18109 • TEL 610-820- 9551 , FAX 610-820-0271

RADIOGRAPHIC INSPECTION REPORT

Customer: Tipco Technologies, Inc. WTTI Job #: JOB 15234 Test Date(s): 2/18/2019 Welder's Name: Ricky Spradlin Material Type: A/SA-312 TP304L Reinforcement Thickness: 0.063"

Procedure No.: RT-1 Rev. 7 Material Thickness: 0.218" Weld Thickness: 0.218"

X-Ray KV: 150 MA: 7 Penetrameter: Source Side

Diameter I Length: 2" Sch. 80 Spot Size: Large

Size: IA / #5 Shim Material: None Used Screens Front: 0.005"

Shim Thickness: n/a Back: 0.010"

Geometric Unsharpness (UG) Less Than: 0.020"

"'O > ::c 0

00 � � d ;-....� � r,, IJQ -= t')

� - -

Weld Identification 201902246 (0) X

201902246 (90) X

Comments: n/a Acceptance Standard: ASME Section IX - 2017 Inspector: Leonard J. Macikonycz NDT Level II / WTII

n ., = t')

:ii:-

-

n n - = C: rJl -3

> = r 0 0 = i: r = = = :i

"!l!j � < C. ., = "' ;' IJQ

;i '"Cl = � ., r,, � r,, < � t') t') -

= s· � � = � � t')

= -

= -

X

Source to Film Distance: 54" Exposure Time: 30 Seconds

Type: Wire IQI

0 -

=-�

Remarks

2G,GTAW 2G, GTAW (Surface acceptable)

Authorized By: � / � Report Date: 2/18/2019

ft fAc«EDITffl ll·Sll�OCI RI =;�;o.o�

QUALITY POLICY STATEMENT 11,e services reported in this document were performed in accordance wilh Welder Training and Testing lnstitute's Quality System, governed by Quality Manual, Rev. 18, ////2//8 and AWS Accredited Test Facility (Cert. #900201). WTTI is accredited by A2LA to ISO 17025/or the test methods listed on Testing CerL 3430.01 and 3430.02. 17ie Scope of Accredilation is available at www.wlli.com. 11iese recorded results represent only the specimen{s) tested and are in compliance with applicable code{s), standard(s), and/or contract requirement{s). At no point during testing or inspection at WTTI's facility has this item come into direct contact with mercury, mercury compounds, or devices containing single boundary containment of such.

Page I of I