Rear Plate Bumper5th Gen 4 Runner

i n s t a l l a t i o n i n s t r u c t i o n s

Hardware: q (4) – 12mm x 1.25 x 40mm q (8) – 1/2” SAE washers q (8) – 1/2” USS washers q (4) – 8mm x 1.25 x 45mm q (4) – 5/16” flat washers q (1) – 6’ body trim

5 T H G E N R E A R P L A T E B U M P E R I N S T A L L A T I O N I N S T R U C T I O N Spage 1–2

• Remove lower bumper hardwareThere are multiple clips and bolts that will need to be removed form the lower portion of the factory bumper. This section will be cut and discarded.

NOTE: Not all clips and bolts that need to be removed are pictured.

• Cut lower bumperFind the cut line by taking measurements as shown. Take your first measurement from the body line where the flare meets the body. Your first mark will be 5.25” down from this line. Take the second measurement from the same line, just where it starts to angle up. This mark will be 5.75” down from the body line. Use masking tape to form a line between these two marks. From there follow the body line where the gate closes as shown.

• Bracket Removal

These brackets will need to be cut off from both sides.

For questions or further help:

Call: 866-522-0697Email: info@cbioffroadfab.com

• Final cut and hitch removalYour final cut should look like the one shown. Once the lower portion of the bumper is removed you can remove the factory hitch. Save the hardware for the new bumper install.

NOTE: It may be necessary to fine tune your cut once you see how the bumper will sit.

Rear Plate Bumper5th Gen 4 Runner

i n s t a l l a t i o n i n s t r u c t i o n s

Hardware: q (4) – 12mm x 1.25 x 40mm q (8) – 1/2” SAE washers q (8) – 1/2” USS washers q (4) – 8mm x 1.25 x 45mm q (4) – 5/16” flat washers q (1) – 6’ body trim

5 T H G E N R E A R P L A T E B U M P E R I N S T A L L A T I O N I N S T R U C T I O N Spage 2–2

• Bracket & exhaust removalRemove tow hooks and bumper brackets from both sides of the frame. Remove the rear exhaust from hanger.

NOTE: It may be necessary to bend and/or cut the exhaust hanger down for clearance after install.

NOTE: It may be necessary to smooth the sides and bottom of the frame rails for proper fit when installing the bumper.

• Bumper installPosition the bumper on the frame rails. Once in place slide the spacer brackets in between the bumper and frame rails. Use the 8mm hardware and washer plates in the four outer holes of the frame. At this point double check your cut line and make adjustments as needed on both sides of the vehicle. Once the cut line looks good remove bumper and install the rubber body trim.

NOTE: You may need to remove and reinstall the bumper when checking the cut line.

For questions or further help:

Call: 866-522-0697Email: info@cbioffroadfab.com

• Final installAfter the trim is added reinstall the bumper using the 8mm and 12mm hardware as shown in the previous step. Use the bolts from the factory hitch to secure the mid section of the bumper. Two above the hitch and two below.