satellite transceiver hz410 r2
TRANSCRIPT
Newtec
www.newtec.eu
Description
The HZ410 is a professional satellite to terrestrial transceiver used in mobile and terrestrial television networks where the content is distributed to the transmission towers via satellite.
The HZ410 integrates a satellite demodulator, a DVB-S/S2 fi ltering module, an interface card with multiple ASI and IP outputs and a DVB-T/DVB-H COFDM modulator.
The HZ410 transceivers are compact units to be installed in each of the remote transmission towers. Each transceiver unit integrates all the building blocks necessary to receive one satellite carrier transporting one or several television multiplexes, extract one or several television multiplexes from this carrier, synchronize one of these multiplexes with other transmission towers (for SFN operation) and modulate this signal to be transmitted terrestrially to the set-top boxes or mobile handsets. A second multiplex can be made available on the second (LP) input of the terrestrial modulator while additional multiplexes extracted from the satellite carrier can be distributed by the HZ410 to external terrestrial modulators via ASI or IP.
The HZ410 off ers the possibility to work in Multistream mode, an advanced feature of the DVB-S2 standard. This technology allows the operator to distribute multiple multiplexes on the same satellite carrier. This Multistream functionality does not aff ect the content of the multiplexes and is therefore fully compatible with SFN operation. Unlike multiple carrier confi gurations, this mode of satellite transmission allows operating near transponder saturation and therefore optimizes the bandwidth effi ciency.
Key features
• Compliant with DVB-S2 and DVB-S/DSNG• Compliant with DVB-T and DVB-H• Operation in MFN and SFN• Multistream Operation• Integrated GPS receiver• Up conversion to VHF or UHF band• Remote management
Main advantages
• Compact and cost-effi cient design• Highest satellite bandwidth effi ciency • Fast and uniform network deployment • Easy installation and maintenance
Applications
The core application of Horizon is the primary distribution of TV signals to terrestrial towers in mobile TV or Terrestrial TV networks. The HZ410 supports the following operation modes:
• Primary distribution of DVB-T or DVB-H content to broadcast towers
• Distribution of DVB-T or DVB-H services together with other services sent on the same satellite carrier
• Deployment in regional towers where intermediary processing by external devices need to take place between the satellite reception and the re-modulation
in COFDM.
This product can be installed in any transmission site, from high-power one to smaller gapfi llers.
Related products
HZ930 – Deconcentrator-ReceiverHZ932 – Dual Deconcentrator-ReceiverHZ920 – Intelligent satellite receiver for DVB-T/H networksHZ420 – Intelligent satellite to terrestrial transceiver for DVB-T/H networksDVB-S2 link budget calculator (free download)
Related documents
White paper ‘The SatFlow concept’: Flexible primary distribution of Mobile TV content over Satellite
HZ410Satellite to terrestrial transceiver for DVB-T/H networksHorizon Product Family
R2/05/05.2008
Demodulator part
Supported modulation parameters
• DVB-S2 QPSK & 8PSK, (16APSK option) 0,256 - 30 Mbaud (45 Mbaud option)• DVB-S/DSNG QPSK, 8PSK, (16QAM option) 1- 30 Mbaud (45 Mbaud option)
L-band input: dual input
• input: 75 Ohm on MCX(F), 950-2150 MHz, -25 to -65dBm + 10 log(f ) f= Baudrate in Mbaud
• return loss > 7 dB
LNB power and control
• max. current: 350 mA (on selected L-band input)• 11.5-14 V (vertical), 16-19 V (horizontal), 22 KHz ± 4 kHz ,DiSEqC
Performance
Performance in DVB-S2:Measured performance for PER 1E-5 (BER ~ 5E-8), normal frames
Multistream operation
• Compliant with DVB-S2 Multistream CCM or VCM (Optional)• Extraction of one stream and modulation in COFDM
This feature is only available in DVB-S2 mode.In Multistream mode (optional), availability of other streams on thesecond ASI output or on the IP output.
Data Interfaces
• 2 ASI output with streams from the demodulator• 1 Ethernet output for IP streams received by the demodulator• 2 ASI inputs (Redundant or hierarchical) to the COFDM modulator
Modulator part
Supported modes
DVB-T (EN 300 744) and DVB-H (TR 102 377), including• IFFT: 2K, 4K and 8K• Guard interval: 1/4, 1/8, 1/16, 1/32• Code rates: 1/2, 2/3, 3/4, 5/6, 7/8 • Constellations: QPSK, 16QAM, 64QAM• 5, 6, 7 or 8 MHz channel mode
SFN sync input (option)
• Compliant to TS 101 191• 10 MHz external input, BNC 50Ω • 1 PPS external input, BNC 50Ω • GPS antenna input on BNC 50Ω
RF data output
• N connector 50Ω, 0 dBm nominal output level• Frequency: 30MHz to 1GHz (steps of 1 Hz)• Shoulder level: ≤-50dB at nom. level (sidebands excluded)• MER value: ≥48dB in 2K, 4K and 8K mode
Digital Pre-correction (option)
• Linear correction: Magnitude and group delay correction• Non-linear correction: full I & Q amplitude and phase corrector with
independent correction of upper and lower sideband
Generic
Monitor and control interfaces
a) Web server GUI (HTTP) via web browser (Ethernet RJ 45)b) RMCP version 2 (9-pins SUB-D Female)c) RMCP v2 on TCP/IP) and SNMP on UDP) (Ethernet RJ-45)
Alarm interface
9-pins SUB-D Female interfaceOutput: Generic device and Interface alarms Input: separate reset and output muting control
Mechanical
1RU, width 19”, depth 15,3”, 5kgPower Supply90-130 and 180-260 Vac, 80VA
Environmental
Temperature: - Operation 5° to +35°C, - Storage -40° to +70°CHumidity: 5% to 85% non-condensingCE Label
Ordering information
(*) upgradeable via license key
Confi g Min Es/No
QPSK- 1/3 -0.7QPSK- 2/5 0.2QPSK- ½ 1.4QPSK- 3/5 2.8QPSK- 2/3 3.6QPSK- ¾ 4.3QPSK- 4/5 5.1QPSK- 5/6 5.5QPSK- 8/9 6.6QPSK- 9/10 6.7
Confi g Min Es/No
8PSK- 3/5 6.38PSK- 2/3 7.18PSK- ¾ 8.48PSK- 5/6 9.78PSK- 8/9 11.18PSK- 9/10 11.316APSK- 2/3 9.616APSK- 3/4 10.516APSK- 4/5 11.516APSK- 5/6 12.116APSK- 8/9 13.316APSK- 9/10 13.6
Europe North-America South-America Asia-Pacifi c China MENA Africa
Tel: +32 3 780 65 00 Tel: +1 (203) 323-0042 Tel: +55 (11) 2092 6220 Tel: +65 6777 22 08 Tel: +86 10-823 18 730 Tel: +971 4 390 18 78 Tel: +27 11 640 2745
Fax: +32 3 780 65 49 Fax: +1 (203) 323-8406 Fax: +55 (11) 2093 3756 Fax: +65 6777 08 87 Fax: +86 10-823 18 731 Fax: +971 4 368 67 68 [email protected]
©2008, Newtec Cy. All information subject to change. All rights reservedThe specifi cations of products and services mentioned herein can be modifi ed at any time without prior notice
Specifi cations
HZ410 MULTISTREAM TRANSCEIVER Order n°
Default Confi guration
DVB-S/DVB-DSNG/DVB-S2, L-band input, ASI output/IP output,Up-conversion to VHF (Band III) and UHF (band IV and V)SNMP client, QPSK-8PSK 30Mbaud, CCM Single-Stream, MFN operation
HZ420
Confi guration options
Category Max. 1 option per category
Modulation &Baud rate
QPSK-8PSK 30Mbaud * Default
QPSK-8PSK 45Mbaud * HA-02
QSPK-8PSK-16APSK/16QAM 30Mbaud * HA-03
QSPK-8PSK-16APSK/16QAM 45Mbaud * HA-04
MFN/SFN support
MFN Default
SFN (with external receiver) HD-02
SFN with internal GPS receiver HD-03
Additional options
Multistream VCM, Multistream* HB-02
Precorrection Linear and non-linear precorrection* HE-02
DVB-S or
DVB-S2Demod. GPS Sync
COFDM
modulator
Transport stream input on up to 2 ASITransport stream output on up to 2 ASI and 1 IP output
1 xUHF or VHF