second exam summer 2010
TRANSCRIPT
-
7/31/2019 Second Exam Summer 2010
1/9
Kuwait University
Electrical Engineering Department
ENG 205 Fundamentals of Electrical Engineering
Summer 2009-2010 Second Exam
July 15, 2010
Instructions:
1) Verify your name and ID number below.2) Have ready on the table a photo ID card.3) Use only the sheets given to you in the exam.4) No mobile phones are allowed Leave yours with the Engineer after
switching it off.5) No borrowing of calculators allowed. Bring your own.6) Exam Duration: 5:00 - 6:30 PM7) No textbooks, notes or sheets are allowed in the exam.
Name: Name
ID: ID
Section: Section
Professor: Professor
Bldg Room
ENG 205 Second Exam July 15, 2010 SN: SN
-
7/31/2019 Second Exam Summer 2010
2/9
Question 1:
A) How many essential nodes are there in the circuit ?
B) How many Node-Voltage equations are required to solve the circuit ?
C) How many constraint equations are required using the Node-Voltage method ?
D) How many meshes are there in the circuit ?
E) How many Mesh-Current equations are required to solve the circuit ?
F) How many constraint equations are required using the Mesh-Current method ?
G) Which method is best suited to solve the circuit ?
H) Write the node voltage equations required to solve the circuit.
A)
B)
C)
D)
E)
F)
G)
ENG 205 Second Exam July 15, 2010 SN: SN
150 A 3 S 7 S
5 S
4 S
6 S
8 S
74 A
100 A
15 A
191 A23 A
-
7/31/2019 Second Exam Summer 2010
3/9
Question 1 (Contd.):
ENG 205 Second Exam July 15, 2010 SN: SN
-
7/31/2019 Second Exam Summer 2010
4/9
Question 2:
Use the mesh current method to find V0
V0 =
ENG 205 Second Exam July 15, 2010 SN: SN
+
-5
+
-
5
40 10
+
V0
-
1.5x6V020 V
Ix
-
7/31/2019 Second Exam Summer 2010
5/9
Question 2 (Contd.):
ENG 205 Second Exam July 15, 2010 SN: SN
-
7/31/2019 Second Exam Summer 2010
6/9
Question 3:
Use the principle of super position to find v0 in the circuit (Use the node voltage
method in your solution whenever possible).
v0 =
ENG 205 Second Exam July 15, 2010 SN: SN
-
7/31/2019 Second Exam Summer 2010
7/9
Question 3 (Contd.):
ENG 205 Second Exam July 15, 2010 SN: SN
-
7/31/2019 Second Exam Summer 2010
8/9
Question 4:
The variable resistor (R0) in the circuit is adjusted until the power dissipated in the
resistor in 250W. Use Thevenins theorem to find the value ofR0 that satisfy this
condition.
R0 =
ENG 205 Second Exam July 15, 2010 SN: SN
,
-
7/31/2019 Second Exam Summer 2010
9/9
Question 4 (Contd.):
ENG 205 Second Exam July 15, 2010 SN: SN