sencon portable tray - rehabmart.com · 2018. 4. 5. · manual, contact sencon customer service at...
TRANSCRIPT
SENCON PORTABLE TRAY User Manual
Contents SENCON PORTABLE TRAY .................................................................................................................... 1
Safety always ................................................................................................................................... 4
What comes in the box?.................................................................................................................. 5
Sencon Portable Tray installation ................................................................................................... 6
(Back support assembly) ............................................................................................................. 6
Sencon Portable Tray installation ................................................................................................. 11
(Footrest assembly) ................................................................................................................... 11
Warranty ....................................................................................................................................... 18
Assembly, Installation and Operating Instructions
WARNING
DO NOT install this equipment without first reading and understanding this instruction sheet. If you are unable to understand these instructions, contact a healthcare professional, dealer or technical personnel before attempting to install this equipment - otherwise, injury or damage may occur. Check all parts for shipping damage. In case of shipping damage, DO NOT use. Contact Carrier/Dealer for further instruction. Make sure that tray is properly secured to the wheelchair at ALL times. If you are unable to understand this instructions, warnings or cautions contained within this manual, contact Sencon Customer Service at [email protected]. PRIOR to operating or servicing this SENCON Portable Tray; otherwise injury to the operator or damage to the equipment may result.
Safety always
The same basic
balance rules apply
with the use of the
Sencon Portable Tray
as with a standard
wheelchair.
Do not exceed the
weight limit of your
wheelchair as stated in
your wheelchair
manual
Do not exceed the
weight limit of the
Sencon Portable Tray
At all times, make sure
the joints are properly
locked
Do not submerge the Mounting System or wash it with water. Clean it with a dry rag.
What comes in the box? (Contents may vary from one kit to another)
Sencon Portable Tray x1* 7/8” - 3/4” Indexed clamp x1*
18” length straight 3/4" tube with 2 holes x1* Handle for Clamp x1**
Clamp Quick Release Assembly 1"*** 3/4” - 3/4” Indexed clamp x1***
18” length straight 3/4" tube x1*** 5mm Allen wrench**
4mm Hex (x2) screw and cap nuts (x2) 4mm Allen wrench**
*Back support assembly kit; contents may be different with other kits ** Back support assembly kit; other styles may apply ***Footrest assembly kit
Sencon Portable Tray installation (Back support assembly)
1
Remove the backrest of the wheelchair in order to install the 7/8” -
3/4” Indexed clamp around the tube
With the help of the handle, open the clamp mechanism to install it on the tube of the wheelchair
Tight the handle
2
Insert the 18” length straight 3/4" tube into the Sencon portable tray
by aligning the holes in it with those in the tube.
3
Insert the screws and tight the cap nuts.
4
Loose the handle (clamp) just a little. Enough for the tube to enter
but also to locate the clamp at the most suitable and comfortable way.
5
Tight the handle
6
Enjoy your Sencon Portable Tray
7
Remember you have two options to use it.
Folding mode:
With the palm of your hand, push the auxiliary surface out and let the mechanism swing in.
Extended mode:
With the palm of your hand, push the auxiliary surface out and let the mechanism swing out.
Sencon Portable Tray installation (Footrest assembly)
1
Know the Quick Release clamp and its elements
2
Release the footrest clamp and install it on the wheelchair. For this
you will have to use the 4mm Allen wrench
Quick Release Handle
Footrest clamp
Tube clamp
Joint released Joint
Screws that release/secure
the tube clamp
Tube clamp released
Screws that
release/secure the
footrest clamp
Screw that
alows the joint
adjustment
3
Use the 5mm Allen wrench to vertically adjust the joint.
4
Prepare the other parts to connect them with the QuickRelease
Clamp looking for the final assembly look like this.
6
First, take the Sencon Portable Tray and the 18” length straight 3/4”
tube with holes.
Insert the tube in the direction as shown in the image until the holes are aligned.
Insert the screws and tight the cap nuts.
7
Use the handle to release the device where the 18” length straight
3/4” tube will attach.
8
Using the 5 mm wrench loose the device. Once the walls are
separated insert the tube.
Close again the wall using the Allen Wrench
Put the device on the clamp and tight the handle.
9
Take the 3/4”-3/4” indexed clamp and using the 5mm Allen wrench
loose the joint.
By loosening it you can adjust one part of the clamp so it receives the tube with the Sencon Portable Tray and the other part so it receives the tube coming from the Quick Release clamp.
10
Enjoy your Sencon Portable Tray
11
Remember you have two options to use it.
Folding mode:
With the palm of your hand, push the auxiliary surface out and let the mechanism swing in.
Extended mode:
With the palm of your hand, push the auxiliary surface out and let the mechanism swing out.
Warranty
Warranty Information
IMPORTANT: READ CAREFULLY
Subject to the terms and conditions below, SENCON warrants to the original purchaser of a Sencon
Portable Tray (the “Product”) that the Product shall be free from defects in material and
workmanship for one (1) year from the date of purchase (the “Warranty Period”). If a defect covered
by this limited warranty occurs during the Warranty Period, the Company will repair or replace, at
its option, the defective Product free of charge. However, costs associated with shipping the Product
in connection with obtaining warranty service shall be at the purchaser’s expense. The Company’s
repair or replacement shall be purchaser’s exclusive remedy with respect to any breach of the
limited warranty.
NOTE: The customer must notify SENCON of any defect, malfunction, or nonconformity promptly upon discovery, and must receive authorization from Sencon to return the product by emailing [email protected].
Sencon S.A.S
Cali, Colombia [email protected]
[email protected] www.sencon.com.co