side instrument bezel and controls
TRANSCRIPT
-
7/28/2019 Side Instrument Bezel and Controls
1/2
-
7/28/2019 Side Instrument Bezel and Controls
2/2
ALTERNATOR ALERT ,This warning light (5) comes on along with an audible alarm to alert the operator
that the battery is not charging. 1/ this light should come on d uring operation or
remain on alter initial start-up have the charging system checked as soon as
possible by an;authorized Komatsu Dealer.
AIR CLEANER RESTRICTION ALERT
This warning light (9) comes on when the engine air filter is restricted. If this
indicator comes on during operation, shut the machine down and have the air
filter system serviced. Do not operate the machine with a restricted air filtering
system; damage to the engine may result.
GLOW PLUGS PREHEAT INDICATION
In cold weather during initial start-up there is a need to preheat the combustion
air to aid in starting the engine. To use this feature, hold the Ignition switch in
the prcheut position lor approximately 30 seconds, the indicator light (6) will
come on and remain on for about 30 seconds, after the light goes out the engine
may be cranked. This procedure may have to be repeated one more time.
Duo to the glow plug feature equipped with this machine, do not
use Ether or other starting aids. Damage to the engine or
possible injury to the operator may result
ENGINE COOLANT TEMPERATURE ALERT
This warning light (7) comes on along with an audible alarm to alert the operator
of an engine overheat condition. If this warning and alarm should come on,
immediately stop the machine and select neutral gear. Lei the engine runs at
about 1200 RPM until the warning and alarm stop. If this condition should occur
again, check to make sure the radiator fins arc clean and free of debris. Do not
continue to operate the machine if the engine is overheating.
ENGINE OIL PRESSURE ALERT
This warning lamp (8) comes on along with an audible alarm to alert the operator
of an engine oil pressure loss. If this light should come on during operation or
remain on after start-up, shut the engine down immediately. If this light does not
come on when the ignition key is turned on. Have the system checked by your
Komatsu dealer. Do not
operate the machine If their light cornel on when the ignition key is immediately
Damage to the engine may result.
ROTATING BEACON LAMP (IF EQUIPPED)
This light (16) comes on when the revolving light is operated by means of the
switch positioned on the upper right side of the cab
AUDIBLE WARNING SYSTEM
When the ignition switch is on or the machine is in operation this audible alarm
(10) will sound if:
The engine oil pressure is low The engine is overheating The
transmission is overheating
Faulty alternator
Incorrect position of seat while machine is moving The charging system
has failed
JOYSTICK LOCK SWITCH
When travelling on roads, always engage the joystick locking device. This switch
(11) inhibits the joystick controls, it is used when the machine travels on roads and
as safety lock when leaving the drivers seat or parking the machine. To lock the
joystick controls, press switch (11) ON (switch illuminated). Press the switch again
OFF to release the controls.
Whenever the machine i s started, the controls are locked automatically
ON (switch illuminated). pp::.s the switch Off id use the control*.
l or safety r easons, the joystick controls are locked automatically (LED
on) (switch illuminated) when the seat is rotated by the operator to
change driving position. The joystick controls arc automatically released
OFF when the rotation has been completed and the scat is in a fixed
driving position (front or rear).In the version with backhoe joystick controls, this button serves to lockthe backhoe controls, too.