HOW TO MAKE THREADING IN SOLID WORKS

OPEN THE SOLID WORKS

CLICK NEW BUTTON SELECT PART OK

SKETCHSELECT PLANE (FRONT)

CLICK CIRCLEDRAW A CIRCLEEDIT THE DIMENTION

GO TO FEATURESCLICK EXTRUDED BOSS/BASE

EXTRUDE TO THE REQUIRED SIZE

GO TO SKETCHSELECT A PLANE

DRAW A CIRCLE TO THE DIAMETER OF THE CYLINDER

COMPLETE THE CIRCLE AND CLICK OK

CLICK FEATURES CURVESHELICAL AND SPIRAL

SELECT PITCH DEPTH, NO. OF REVOLUTION AND ANGLE

(FOUND ON LEFT SIDE) AND CLICK OK

GO TO SKETCHSELECT PLANE PERPENDICULAR TO

COMPONENT(RIGHT PLANE)CLICK OK (NORMAL TO)

DRAW A CIRCLE OF DIAMETER TO THE REQUIRED NEED OF DEPTH CUT

PRESS AND HOLD CTRL BUTTON AND CLICK THE CENTRE

OF CIRCLE AND THE HELICAL PATH

AFTER THE CLICKS A PROPERTIES BOX OPENS AT LEFT. IN THAT CLICK PIERCE

(NOTE: THE CENTRE OF CIRCLE GET COINCIDES WITH THE HELICAL PATH)

AFTER THAT GIVE EXIT SKETCH IF SKETCH TOOL IS ON

CLICK FEATURESGO TO SWEPT CUT

SELECT THE PROFILE AND PATH (ON LEFT)

(PROFILE AS CIRCLE AND PATH AS HELICAL)

THUS THREADING HAS BEEN MADE ON THE SOLID

SURFACE(CYLINDER)