sparc t5 systems installation and maintenance

12
Assessment: SPARC T5 Systems Installation and Maintenance (Answer all questions in this section) 1. Which of the statements are correct? Check all that apply. Mark for Review (1) Points (Choose all correct answers) The minimum number of CMs in a T5-8 is 1. The T5-8 CMs and the T5-4 CMs are the same (*) The T5-8 supports 16 PCIe low-profile cards. (*) The T5-8 supports 128 DIMM slots. (*) The T5-2 supports 8 PCIe low-profile cards. Sorry, that is not correct. Please review the course content and try again. 2. Which of the following are members of the SPARC T5 family? Check all that apply. Mark for Review (1) Points (Choose all correct answers) T5-8 (*) T5-1B Blade (*) T5-2 (*) T5-4 (*) T5-6 Correct!

Upload: ermal-cene

Post on 08-Dec-2015

17 views

Category:

Documents


1 download

DESCRIPTION

SPARC T5 Systems Installation and Maintenance

TRANSCRIPT

Page 1: SPARC T5 Systems Installation and Maintenance

Assessment: SPARC T5 Systems Installation and Maintenance (Answer all questions in this section) 1. Which of the statements are correct? Check all that apply. Mark for Review (1) Points (Choose all correct answers) The minimum number of CMs in a T5-8 is 1. The T5-8 CMs and the T5-4 CMs are the same (*) The T5-8 supports 16 PCIe low-profile cards. (*) The T5-8 supports 128 DIMM slots. (*) The T5-2 supports 8 PCIe low-profile cards. Sorry, that is not correct. Please review the course content and try again. 2. Which of the following are members of the SPARC T5 family? Check all that apply. Mark for Review (1) Points (Choose all correct answers) T5-8 (*) T5-1B Blade (*) T5-2 (*) T5-4 (*) T5-6 Correct! 3. The ____ runs its own embedded operating system. Mark for Review (1) Points Logical Domains Manager Oracle ILOM service processor (*)

Page 2: SPARC T5 Systems Installation and Maintenance

Hardware Management Pack OpenBoot PROM Correct! 4. On a T5-2, what is the name of the bottom disk? Mark for Review (1) Points Disk 8 Disk 0 (*) Disk 1 Disk 6 Correct! 5. Which of the following are applicable or characteristic of a "Hot-Swap" component. Mark for Review (1) Points (Choose all correct answers) Typical examples would be PCIe Express modules Typical examples here are a single RAID disk or a power supplies (*) refers to the ability to perform hot-plug operations, with the additional necessity of some operator actions (invocation of a CLI or actuating a hot service button on the component to be removed). refers to an operation where you walk up to the box, yank something out, replace it, and you are done Refers to an operation where you walk up to the system, remove the board or component, replace it, and you are done (*) Sorry, that is not correct. Please review the course content and try again. 6. During a service call, when replacing the motherboard, how do you preserve the server's original host ID and MAC addreess? Mark for Review (1) Points Move the service processor card from the old system to the new system.

Page 3: SPARC T5 Systems Installation and Maintenance

Back up the service processor configuration details from the old system, and restore on the new system. Move the System Configuration PROM from the old motherboard to the new motherboard. (*) For security, it is not possible to preserve the server's host ID and MAC address. Correct! 7. Which of the statements are correct? Check all that apply. Mark for Review (1) Points (Choose all correct answers) While 32GB DIMMs will work on the blade, only the 16GB DIMM is being qualified. (*) The T5-1B integrates into the Sun Blade 6000 architecture. (*) The T5-1B features RAID 0, 1 and hot-plug disks. (*) The T5-1B supports 2x hot-plug PCIe 2.0 x8 Express Modules (*) The T5-1B supports 2x hot-plug PCIe 3.0 x8 Express Modules Sorry, that is not correct. Please review the course content and try again. 8. Which of the following power management features are available for SPARC T5? Mark for Review (1) Points (Choose all correct answers) Dynamic Voltage & Frequency Scaling (DVFS) (*) Coherency Link Scaling (*) IFS (Intelligent Fan Control) (*) Cycle Skipping (*) Sorry, that is not correct. Please review the course content and try again.

Page 4: SPARC T5 Systems Installation and Maintenance

9. What is the minimum number of installed power supplies that are required if you want to hot-swap a power supply on a SPARC T5-8 server? Mark for Review (1) Points 3 (*) 2 1 4 Sorry, that is not correct. Please review the course content and try again. 10. Which of the following are applicable or characteristic of a "Hot-Service" component. Mark for Review (1) Points (Choose all correct answers) Typical examples would be PCIe Express modules (*) refers to the ability to perform hot-plug operations, with the additional necessity of some operator actions (invocation of a CLI or actuating a hot service button on the component to be removed) (*) refers to an operation where you walk up to the box, yank something out, replace it, and you are done Refers to an operation where you walk up to the system, remove the board or component, replace it, and you are done The system will notify the user when it is safe to remove the component (*) Sorry, that is not correct. Please review the course content and try again. 11. Which of the statements are correct? Check all that apply. Mark for Review (1) Points (Choose all correct answers) The T5-8 supports 8 HDD or SSDs. (*) The T5-8 has hot-plug disks and PCIe cards. (*) The T5-8 has redundant and hot-swappable fans and power supplies. (*) The T5-8 supports 1, 2, 3, or 4 Compute Modules.

Page 5: SPARC T5 Systems Installation and Maintenance

The T5-8 supports 16 HDD or SSDs. Correct! 12. Which of the following are elements of higher RAS for SPARC T5? Mark for Review (1) Points Solaris 11 FMA All of the above. (*) SPARC T5 processor and system architecture I/O and Memory OVM Hypervisor Correct! 13. Which PCIe slots are available in a T5-4 system with one CM? Mark for Review (1) Points One through fifteen One through sixteen One through eight One through fourteen (*) Sorry, that is not correct. Please review the course content and try again. 14. What is Critical Thread Optimization? Mark for Review (1) Points Recognized by Oracle Solaris Scheduler as a thread that should run by itself on a single core (*) The ability to bind individual threads to a processor The ability to dynamically alloate core resources among active threads

Page 6: SPARC T5 Systems Installation and Maintenance

Part of the Processor Sets feature of Oracle Solaris that defines a group of logical processors and schedules threads on them Sorry, that is not correct. Please review the course content and try again. 15. Which three options are formal steps in the EIS methodology? Mark for Review (1) Points (Choose all correct answers) System sizing Installation configuration planning (*) Site audit (*) System test (*) Sorry, that is not correct. Please review the course content and try again. 16. What is out-of-order execution? Mark for Review (1) Points A feature of certain multicore processors, where a core can be given processing priority over other cores A feature of certain operating systems, where programs are executed based on the availability of data A memory architecture feature, where specific data can be delivered to processors at the fastest possible rate A feature of certain processors, where instructions are processed based on the availability of data (*) Sorry, that is not correct. Please review the course content and try again. 17. In general, when labeling a cable, the host connection should follow the format: and ____. Mark for Review (1) Points <cable no.> <insertion point> <port no.> (*)

Page 7: SPARC T5 Systems Installation and Maintenance

<rack no.> Sorry, that is not correct. Please review the course content and try again. 18. What is the primary purpose of the EIS Test Procedure Plan? Mark for Review (1) Points To confirm that the Explorer Data Collector has been run and analyzed by the Oracle Risk Analysis System To formally document and present the output of the Sun Validation Test Suite (SunVTS) To generate a test plan and related scripts to be run by the customer to validate the EIS installation To capture and agree on the tests that will be applied by the installer to Oracle products during an EIS installation (*) Sorry, that is not correct. Please review the course content and try again. 19. In a T5-8 with two active CMs, what are in the other two CM slots? Mark for Review (1) Points Full CMs with no CPU and no DIMMs They have to be empty for airflow. PFM is a Processor Module Filler Board, or Processor Filler Module. (*) Nothing, they can be empty. Correct! 20. Which of the following are Virtualization capabilities of the SPARC T5 solution? Mark for Review (1) Points (Choose all correct answers) iPARS Logical Domains (*)

Page 8: SPARC T5 Systems Installation and Maintenance

LPARS Oracle Solaris Zones (*) Dynamic Domains Correct! 21. Which of the statements are correct? Check all that apply. Mark for Review (1) Points The T5-4 uses the same SP as the T4-4 The T5-4 uses the same PCIe cards as the T4-4 The T5-4 uses the same SP, power supplies, disks, DIMMs and CPU as the T5-8 (*) The T5-4 uses the same CMs as the T4-4. The T5-4 uses the same power supply as the T4-4 Sorry, that is not correct. Please review the course content and try again. 22. In order to consolidate the applications on a SPARC T5 server, you require virtual machines that run an independent operating system instance. Which virtualization technology did you select? Mark for Review (1) Points Oracle Solaris Containers Oracle VM Server for SPARC (*) Oracle VirtualBox Dynamic Domains Correct! 23. Which of the statements are correct? Check all that apply. Mark for Review (1) Points (Choose all correct answers) The 8-way architecture can grow to 128 or 256 processors.

Page 9: SPARC T5 Systems Installation and Maintenance

Using a crossbar switch would have allowed for point-to-point communications, but would have added latency and cost to the server. (*) The 4-way T3 and T4 used snoopy-based communication between CPUs, but this slows performance down for larger 8-way system. (*) The best design is providing 7 links per CPU so the server could grow to 8-way glueless. (*) Sorry, that is not correct. Please review the course content and try again. 24. ILOM supports which interface capabilities? Mark for Review (1) Points (Choose all correct answers) rKVMS (*) BlueTooth Console Redirection (*) IPMI (*) CLI or Browser (*) Sorry, that is not correct. Please review the course content and try again. 25. Which of the statements are correct? Check all that apply. Mark for Review (1) Points (Choose all correct answers) The T5-2 has 8 drive bays The T5-2 has 6 drive bays (*) The T5-2 supports 6 of the 10GbE ports The T5-2 supports 32 DIMM slots (*) The T5-2 supports 8 PCIe low-profile cards. (*) Correct!