E-SAMPLER

Sales & Service: 1600 Washington Boulevard, Grants Pass, Oregon 97526 • Tel 541/471-7111, Fax 541/471-7116

Regional Sales & Service: 3206 Main Street, Suite 106, Rowlett, Texas 75088 • Tel 972/412-4747, Fax 972/412-4716

http://www.metone.com

SpecificationsConcentration Ranges (Auto-ranging) 0-0.5, 0-1, 0-10 0-65

mg/m3Laser 670 nm, 5 mWSensitivity 0.001mg/m3Sample Period 1 secSample Flow Rate 2 LPMPump Type Diaphram 10,000 hrAccuracy 8% of NIOSH 0600Precision 0.003 mg/m3 or 2%

readingParticle Size Sensitivity Range 0.1-100 micronLong term Stability 5% readingSensor Type Forward Light ScatterAverage Period 1 – 60 minutesDisplay 4X20 LCDInternal Battery (Optional) 12 VDC 12 Amp-Hr,

lead acidPower Consumption 350mA (no heater)

1.1 A (w/heater)Internal Battery Operation, no heater >30 Hours

with heater 10 HoursBattery Type Lead AcidSize 10.5 (267) X 9.25

(235) X 5.7 (145)inches (mm)

MOI Service Period 2 yrsProgrammable Auto-Zero 15min to 24 hoursProgrammable Auto-Span 15min to 24 hoursTraceable Testing GravimetricSample Line Heater Configurable RH Con-

trolledOutputs Analog 0-1,0-2.5,

0-5VDC, RS232Data Storage Capacity 12000 RecordsTemperature Compensation StandardTemperature Range -30C to +50CRH Measurement InternalAmbient Temperature -30C to +50CAmbient Pressure 1040 to 600 mbarsAlarm Contact ClosureAvailable Cut Points TSP, PM10, PM2.5,

PM1

Standard EquipmentUniversal Voltage Power SupplyBattery Charger Internal47 mm Filter HolderComet SoftwareTSP InletInlet HeaterDigital Output CableInstruction Manual

OptionsPM10, PM2.5, PM1 Sharp-Cut Cyclone

Met One Instruments, Inc.

Specifications

Met One Instruments, Inc.

The New Standard inReal-Time AerosolMonitoring

The E-SAMPLER is the mostfeature-packed light-scatterAerosol Monitor available.Whatever your monitoringneeds, the E-sampler will pro-vide accurate, dependable andrelevant data.

FeaturesProgrammable Auto-ZeroProgrammable Auto-SpanAuto-ranging (1 to 65000µm/m3)Automatic Flow ControlProtocolInternal Battery (30 HoursOperation without heater & 10Hours with heater.)Laser-Diode Precise OpticalEngineIntegral 47mm Analysis FilterAmbient Pressure andTemperatureInternal DataloggerPM10, PM2.5, PM1, TSPMonitoringAluminum WeatherproofEnclosurePurge-Air protected OpticsCompletely Self-ContainedNo Tools Filter Replacement

ApplicationsAmbient Air MonitoringRemediation Site PerimeterMonitoringIndoor Air Quality MonitoringSource MonitoringVisibility MonitoringMobile Monitoring

™

11/08 (REVISED 7/15)

Extra 47 mm Filter HoldersAluminum TripodMicroMet SoftwareRadio ModemPhone ModemSatelliteWind Speed/Direction SensorAmbient RHExternal Battery CableBattery

Low Temperature Option, -40C to +50C

aerosol

continuous

monitoring

E-SAMPLERDual TechnologyThe E-SAMPLER is a dualtechnology instrument thatcombines the unequalled real-time measurement of lightscatter with the accuracy stan-dard of filter methods. Thesimple filter loading processtestifies to the seamless blend-ing of both technologies.Filters can be extracted andreplaced in less than oneminute and filter medium canbe selected based on laborato-ry analysis. Particulate loadingon the filter does not reduceperformance due to the MetOne actual flow control proto-col. Ambient temperature andpressure are measured andactual flow is calculated andcontrolled by the E-SAMPLERmicroprocessor independent offilter loading change.

PrincipleThe E-SAMPLER providesreal-time particulate measure-ment through near-forwardlight scattering. An internalrotary vane pump draws air at2 LPM into the sensing cham-ber where it passes throughvisible laser light. Aerosols inthe air scatter light in propor-tion to the particulate load inthe air. Scattered light is col-lected by precise glass opticsand focused on a PIN diode.Rugged state of the art elec-tronics measure the intensityof the focused light and outputa signal to the CPU. The out-put is linear to concentrationsgreater than 65,000 ug/m3.Every E-SAMPLER is factory

the front panel. Coin slotsenable these filters to beremoved and checked orreplaced without any tools.Filter life for both will exceed 1year in the harshest of condi-tions. All E-SAMPLERS havepurge air from the internal filtersthat continually curtain theoptics. This purge air protection

Aallows the E-S MPLER to be

reporting tool. This softwaresupports modem, radio, directconnection and generatessummary reports as well asrecordings and charts. Cometsoftware included which pro-vides easy to use terminalaccess to E-Sampler data.

used in adverse environ-ments without performancedegradation. Even in harshconditions the E-SAMPLERwill operate to specificationsfor 2 years without need ofrecalibration.

OperationThe E-SAMPLER is rugged,portable and easy to use. Theall aluminum enclosure is notonly rugged but provides elec-tronic stability by filteringpotential RF interference. Set-up is a snap with the quickconnect system which workswith the EX-905 tripod. Forother mounting applications,holes are provided to fasten toany structure. Simply turningthe monitor on will start a sam-ple using the most recentparameters. The unit will con-tinue to operate until userintervention or battery failure.Auto-Zero and Auto-Spanensure that the data collectedwill be of the highest quality.Both Zero and Span can beoperated manually or individu-

™

calibrated using polystyrenelatex spheres of known indexof refraction and diameter atmultiple points to validate lin-earity.

MaintenanceEach E-SAMPLER has twointernal filters (not the 47mmAnalysis Filter) to protect sen-sitive optics and prevent dam-age to the flow components.Both filters are accessible from

ally programmed at varyingtime bases (15 minutes to 24hours). The E-SAMPLER canalso be configured forstart/stop times, recording peri-ods, averaging time and otherparameters.

Data Collection andSoftwareOptional MicroMet Plus is acomplete communications,data collection and data