star wars porg magnet - media.prusaprinters.org · emperor death darth clone chewbacca c3po boba...
TRANSCRIPT
1 hrs
1 pcs
f
0.20 mm
k
0.40 mm
h
PLA
15 g
d
MK3/S
Summary
You can glue a 10 x 1.5 mm round magnet in the base.
Art & Design > 2D Plates & Logos
yoda xwing wars vader trooper tie stormtrooper
starbird star solo sith royal republic ren rebels
rebellion r2d2 porg phasma phase palpatine order
mythosaur maul mandalorian luke lord leia kylo
jedi han guard galactic first fighter fett empire
emperor death darth clone chewbacca c3po boba
alliance
Recommended infill angle: 90°
Low speed and high temperature will create a shiny top surface.
There are "holes" inside the model to make some of the top layers moreuniform, and they were created with 0.2 layer height in mind.
Synth3D
Star Wars PorgMagnet
VIEW IN BROWSER
updated 14. 6. 2019 | published 15. 4. 2019
Print Files (.gcode) DOWNLOAD ALL FILES
801.9 KB
0.97 hrs f 0.20 mm k 0.40 mm h PLA 15.00 g d MK3/S
updated 15. 4. 2019
Model Files (.stl, .3mf, .obj, .amf) DOWNLOAD ALL FILES
6.1 MBupdated 15. 4. 2019
If your top surface is not flat & shiny and you see scarring, then make sureto check this guide: https://bit.ly/2UtN0I1
License
This work is licensed under a Creative Commons (4.0 International License)
Attribution—Noncommercial—Share Alike
✖ | Sharing without ATTRIBUTION ✔ | Remix Culture allowed ✖ | Commercial Use ✖ | Free Cultural Works ✖ | Meets Open Definition
porg.gcode
porg.stl