step 4. how to check specifications of nozzles

8/8/2019 Step 4. How to Check Specifications of Nozzles

http://slidepdf.com/reader/full/step-4-how-to-check-specifications-of-nozzles 1/4

PDMS tutorial from Said: Step 4. How to check specifications of nozzles

This tutorial created by Said Babanli (Azerbaijan). (Created on 26.11.08)

Please send comments or additional info to mail: [email protected]

1

Step 4. How to check specifications of nozzles

Before starting creating pipe and branch you have to know Specs (Specification) of pipe and

branch as well. If you don’t know you can check. Currently we know that branch ends are nozzles.

Let’s check specifications of nozzles.

Let’s check which module currently is activated. From main menu Design….

Pipework is Gray. It means current module is Pipework. To get any info of equipment or its parts

you have to go to module Equipment. From main menu DesignEquipment. Activate Model

editor. Select required equipment and do right click and select Edit equipment.






2

As you can see selected equipment is solid color and others are transparent. If solid color, it means

you are editing current equipment. Select required nozzle.

From main menu select ModifyNozzle Specifications.

As you can see

pressure is 150lb

nominal bore – 150 mm

Let’s check second nozzle.We must exit editing mode of current to start edit part of other equipment.

Do right click on current equipment and select Exit Equipment editor.






3

Currently both of them are solids colors. Select other equipment which nozzle is required to check

and do right click and select Edit equipment.






4

Let’s check specs for second nozzle. Select nozzle and from main menu select ModifyNozzle

Specifications.

As you can see

pressure is 150lb

nominal bore – 150 mm

It means they have same pressure and same diameter. Diameter is not problem we can use

somewhere in branch reducer or increaser. But pressure and other specs have to same otherwise you

will get message incompatibility as shown bellow during constructing components to branch. Do

right click on current equipment and select Exit Equipment editor. This all of them required to

prevent error messages and to make job properly. After we will try to make a bit complicated pipe.

step 4. how to check specifications of nozzles

Documents