steps to configure one sensor gary tipton. the hardware: retro-reflective photo sensor
TRANSCRIPT
Steps To Configure One Sensor
Gary Tipton
The Hardware:
Retro-reflective Photo Sensor
Actual Sensor
Device Box
To Configure the sensor:
Open up RS Logix software and select Device Net.
Perform a scan of the system to see if the system recognizes any items in it’s network.
After the device has been observed by the master, than a new address could be assigned to the device.
A better look:
Screen shot
A New Address:
Right click on the device that you want to give a new address to.
Select properties The device information can be manipulated
from there. Re-scan to ensure the new address takes
Properties
Name and Address
Re-Scan