subscribe gallery resources events - wshc.sg · foreseeable risk that may arise during logistic...
TRANSCRIPT
SUBSCRIBE GALLERY RESOURCES EVENTS
26 February 2018 Ref: 1718217
Accident Advisory: Lorry driver fell off lorry bed
On 11 December 2017 around 5pm, a driver was preparing to load goods onto
his lorry. The lorry bed was wet at the time of accident due to rain. While
standing on the lorry’s bed and lowering one of its sideboards, he fell to the
ground from a height of approximately 1.25m. The driver was conveyed to the
hospital where he succumbed to his injuries.
Figure: Overview of accident scene
Recommendations Persons in control of similar workplaces and work activities such as occupiers
and employers are advised to consider the following risk control measures to
prevent similar accidents:
Safe work procedure for releasing side boards
Establish safe work procedures for releasing of vehicle sideboards. The safe
work procedures should include the following, but not limited to:
- ensure vehicle is properly parked at designated areas; - ensure vehicle is stationery; turn off engine, apply the hand brake and
chock the wheels; - stand firm on the ground and not on the lorry bed;
- when unlatching the locking mechanism, the sideboard must be supported;
- Seek assistance from a co-worker if a side board is too heavy for one
person to handle; and - gently lower the sideboard to the desired position.
Location where
deceased was found
Sideboard
of lorry
Ensure the implementation of the safe work procedures through adequate
supervision.
Design of loading/unloading bay
Loading and unloading bays should facilitate safe operations in any
circumstance. For example, adequate shelter and lighting could be provided
so that works during inclement weather conditions or done during the night
can be carried out safely.
Provision for wet weather conditions
Wet weather conditions must be considered if loading/unloading activities
have to be conducted at partially or non-sheltered areas.
Ensure that the lorry bed is safe for access to prevent slips, trips and falls.
Provide slip-resistant safety foot wear.
Risk Assessment Conduct a thorough Risk Assessment (RA) for all work activities to control any
foreseeable risk that may arise during logistic operations. The RA should cover
the following areas, but not limited to:
Work at heights Always eliminate the need for working at heights as far as it is practicable.
Worker Health
Inform workers that they must stop work and report to their supervisors if they are unwell or experiencing fatigue.
Further Information 1. Workplace Safety and Health Act
2. Workplace Safety and Health (Risk Management) Regulations
3. Approved Code of Practice for Working Safety at Heights
4. Approved Code of Practice on Workplace Safety and Health Risk Management
5. Workplace Safety and Health Guidelines on Safe Loading on Vehicles
6. Workplace Safety and Health Guidelines on Workplace Traffic Safety
Management
7. Case Studies Booklet for Accidents Involving Work At Heights
8. Case Studies Booklet for Logistics and Transport Industry
9. 6 Basic Workplace Safety and Health (WSH) Rules for Working at Heights
10.6 Basic Workplace Safety and Health (WSH) Rules for Loading on Vehicles
11.Activity Based Checklist for Working Safely at Heights
12.Activity Based Checklist for Safe Loading of Materials
13.UK HSE – Safety in the Storage and handling of Steel and other Metal Stock
14.UK HSE – A Guide to Workplace Transport Safety
*Information on the accident is provided by the Ministry of Manpower and is correct as at 20 December 2017. This may be subject to change as investigations are still on-going. Please note that the information provided here is not exhaustive and is for the benefit of enhancing workplace safety and health so that a recurrence may be prevented. The information provided is not to be construed as implying any liability to any party nor should it be taken to encapsulate all the responsibilities and obligations of the reader of this WSH Alert under the law.
We regret that we are unable to reply to emails to this address. For enquiries or feedback, please email us at [email protected]. Visit the WSH Council's website now for updates on WSH-related matters, information and events.
This WSH Bulletin is available free of charge, may be printed or downloaded onto electronic, optical or similar storage media provided
that such activities are for private research, study, or in-house use only. If such material is to be copied or reproduced, users are asked
to ensure that the material is reproduced accurately and not in a misleading context, that the status of the material is identified and to
acknowledge Workplace Safety & Health Council, Singapore as the source of the material.
If you wish to update your WSH Bulletin profile, please click here .
If you do not wish to continue receiving the WSH Bulletin by email, please click here to unsubscribe.