technical data sheet and planning guide · bath lift is suitable for your bath. the following...
TRANSCRIPT
arnotec GmbH Grünhutstraße 7 D-76187 Karlsruhe Phone +49 721 605 710 70 Fax +49 721 605 710 19 www.diamantlift.com
Technical Data Sheet
and Planning Guide
Model // Front Mounted Bath Lift //
aarnotec GmbH Grünhutstraße 7 D-76187 Karlsruhe Phone +49 721 605 710 70 Fax +49 721 605 710 19 www.diamantlift.com
This data sheet is a help in order to check if the
bath lift is suitable for your bath. The following
drawings shall help you to determine the requi-
red space of the lift in your bath.
The model Front Mounted Bath Lift is especially
well-suited for small bathrooms and body shaped
bath tubs. In contrary to the other lifts, this device is
mounted in front of the tub.
Model Front Mounted Bath Lift
Engineering drawingFront view of the device with dimensions
Device view model // Front Mounted Bath Lift //
39,0 cm
Ad
just
ab
le f
rom
50
,0 -
64
,0 c
m
45,0 cm
3,6 cm
arnotec GmbH Grünhutstraße 7 D-76187 Karlsruhe Phone +49 721 605 710 70 Fax +49 721 605 710 19 www.diamantlift.com
Engineering drawingDevice view from the right / left
Device view device plate from above
16,0 cm
8,0 cm
34,5 cm
5,0 cm 12,3 cm 12,3 cm
6,0
cm
2,0
cm
Bath tub
Connector for
charger
comfortable
seat- easy to
clean
skin of white plastic
or in fine steel
optics
arnotec GmbH Grünhutstraße 7 D-76187 Karlsruhe Phone +49 721 605 710 70 Fax +49 721 605 710 19 www.diamantlift.com
The dimensions are only for your information.
With each bathlift, we deliver a precise
paper drilling template, which is simply
attached to the place of installation with
adhesive tape. This facilitates the exact
positioning of the drill holes.
Important: Four tight screws are sufficient for
the fixing. You do not have to fix all holes
with screws on the wall.
The delivery includes:
Drilling template, 4x dowels and 4x screws
For the installation you need:
Hex key, screwdriver cross-recess, ratchet
Engineering drawing
Dimension drawing back
39,0 cm
Ad
just
able
fro
m 5
0,0
- 64,
0 cm
45,0 cm
arnotec GmbH Grünhutstraße 7 D-76187 Karlsruhe Phone +49 721 605 710 70 Fax +49 721 605 710 19 www.diamantlift.com
1. Determine an appropriate position for the
installation of your bathlift above the tub. The lift
should be installed in a way that a comfortable
position is granted while lowering and rising. As a
rule, we recommend to install it at 1/3 of the
length of the bathtub.
Make sure that the entering and the sitting
position in the tub meet your demands.
2. Make sure that the wall tolerates the load of
the lift. We recommend the installation on a brick
wall (stone, concrete, masonry...).
For stud walls, secure attachment is not always
possible.
3. The belt must be straightly fed out from the
device and mounted on the floor fixing.
Planning Guide
1/3 2/3
Fixation on the floor
Belt is mounted on the fixation on the
floor
Wall bracket is mounted on the wall
above the tub rim
Belt holder Type A
Belt holder Type C
WallBelt holder Type B
Fixation on the bottom of the tub rim
Belt is mounted on the upper side of
the bathtub rim
arnotec GmbH Grünhutstraße 7 D-76187 Karlsruhe Phone +49 721 605 710 70 Fax +49 721 605 710 19 www.diamantlift.com
The right choice?
Take your measurements: take a ruler and mea-
sure the height of the bathtub. Substract at least
5 cm from the measured value and choose the
standard height that is closest to the calculated
value. (51 cm, 46 cm or 41cm)
Example: Your bathtub has a height of 54 cm
from the floor. After the deduction you have a
value of 49 cm. The closest standard height
would be 46 cm.
Type A (freestanding bathtub)
Available heights are 51cm, 46 cm and
41cm. Is fixed to the floor.
Type B (freestanding bathtub)
Belt holder on the bottom of the tub rim
Type C
Belt holder is fixed to the wall above the
tub rim
Belt holder Type A
Belt holder rangeThree different belt holders are available
Lift Lift
4,2 cm
51
,0 c
m /
46
,0 c
m /
41
,0 c
m
llustration shows a type A beltholder of 46 cm fixed to the floor.
CA B
arnotec GmbH Grünhutstraße 7 D-76187 Karlsruhe Phone +49 721 605 710 70 Fax +49 721 605 710 19 www.diamantlift.com
Belt holder Type B
Belt holder Type C
The belt holder type B can be directly fixed to the
floor (see image on the left).
This belt holder is hardly visible. When the belt
holder is sealed with silicone, wiping up the floor
with water is possible just as before.
Please note:
Type A and B not possible with underfloor heating!
The belt holder Type C will be fixed directly to
the tub rim at the wall side (see picture on the
right).
Belt holder range
15,3 cm
42,5 cm
15,3 cm
2,0
cm4,0
cm
4,0
cm
5,0 cm
15,3 cm
42,5 cm
15,3 cm
6,0 cm
2,0
cm4,0
cm
4,0
cm
5,0 cm
Illustration shows a type B beltholder fixed to the floor.
Illustration shows a type C belt holder fixed to the wall side of the bathtub.
arnotec GmbH Grünhutstraße 7 D-76187 Karlsruhe Phone +49 721 605 710 70 Fax +49 721 605 710 19 www.diamantlift.com
Product type
Application field
Support system
Seating belt
Lifting system
Electrical data
Operating devices
Supporting structure
Transport und
Packing dimensions
Belt bath lift / Band bath lift
Plastic skin
Stainless steel mechanics
with disconnectable fastening
Bathing in sitting or reclining position
Operation by the user
Lowering and rising within the bathtub
Width seating belt ca. 28,0 (cm)
Length seating belt ca. 2,55 (m)
Heat resistant up to 60°C
Electrically adjustable with the buttoms ( ) or ( )
Max. lifting capacity 140 (kg)
Adjustment range 80/100/120/140 (kg)
Motor DC 24V/0,7A (max. 4A)
Number of liftings ca. 10 / depending of lifting height and weight of the person
Battery 2 x 12V/1.2 Ah lead battery, gas-tight
Connector power supply +15 bis 18V DC
Power consumption standby ca. 0,01 mA / 0,1 mW
Loading time ca. 24 hrs. for an empty battery
Depending on the version, contact switch on the device or the remote control
Acoustic charging indicator via beeper, LED on the remote control
Clamping assembly on the side of the bathtub with wall bracket
Width ca. 43,0 (cm) with seat
Height 50,0 (cm) up to ca. 64,0 (cm) adjustable
Depth 7,0 (cm) without seat, 8,0 (cm) with seat
Device weight14,1 (kg)
Tub depth max. 120 (cm)
Length 67,0 (cm)
Width 50,0 (cm)
Height 15,0 (cm)
Weight 16,2 (kg)
Technical specifications
As
of
24
.9.2
01
9
Ve
rsio
n P
-1V
-3
Te
ch
nic
al m
od
ific
atio
ns
an
d e
rro
rs a
re e
xce
pte
d!
arnotec GmbH Grünhutstraße 7 D-76187 Karlsruhe Phone +49 721 605 710 70 Fax +49 721 605 710 19 www.diamantlift.com
Don‘t hesitate to contact us.
We will also be pleased to meet your special
requests.
Telefon + 49 721 605 710 70
E-Mail [email protected]
Please visit us on our website www.diamantlift.com
There you can conveniently choose and order your
lift from home.
Should you need any help, we are at your service
by phone.
Any questions?
Convince yourself of the outstanding quality of
our lifts. You can test our bathlifts at our head-
quarters in Karlsruhe (Germany).