the gold medal trigger the field target trigger for the rapid range

1

Click here to load reader

Upload: graham4877

Post on 18-Apr-2015

54 views

Category:

Documents


4 download

TRANSCRIPT

Page 1: The GOLD MEDAL TRIGGER the Field Target Trigger for the Rapid Range

THEOBEN ENGINEERINGWEST NEWLANDSSOMERSHAMCAMBS. PE28 3EBENGLAND

Tel : 01487 740744Fax : 01487 740040http://www.theoben.co.uk [email protected]

CAMBS. R.F.D. No. 97

H. F. Taylor & D. R. Theobald V.A.T. No. GB 360 0324 05r7_trig_ft 04/00

WHEN CHECKING THE TRIGGER IN THE GUN BODY ALWAYS REMOVE THEBUDDY BOTTLE SO NO FATAL ACCIDENTS OCCUR

Test for safe operation by flicking off the bolt from its back position. If set properly the trigger will hold the hammerback and prevent the rifle from firing off.

THE GOLD MEDAL TRIGGERThe field target trigger for the Rapid range

ADJUSTMENTS

1 Do not adjust the depth of engagement to a knife-edge, this will make the trigger unsafe. However, by decreasingthe depth of engagement a small amount will reduce the amount of travel for the first stage of trigger movement.The spring pressure, acting against point A in the frame controls the pressure on the first stage. Increasing ordecreasing the angle on the part of the spring that acts against point A can change this pressure. To check thatyou have not set the strut spring to fine, the trigger pull should return to its start position if the shot is not taken i.e.all the first stage travel should return smoothly.

2 2nd stage pressure is adjustable by rotating a 2mm allen key - clockwise for higher-pressure etc.3 2nd stage let off position is factory set, but can be fine tuned if necessary by using a screw driver on slot point B

- Clockwise for 2nd stage to be felt earlier.

To remove the trigger cassette from the rifle it is necessary to push out the 1-inch long pin that goes through the gunbody by using a 5/8-inch long 'slave' pin. This way the whole unit stays assembled for inspection.

REMOVING THE TRIGGER

SAFETY CHECK

Point A

Depth of engagement

SEAR

STRUT

Factory setFactory set depthof engagament

1/16 INCHALLEN KEY

Point B

Second stage pressureIN for increase weight 2mm ALLEN

KEY

Trigger pull positionadjustment

Also sideways cant if required

Trigger boss screwsthrough here

2 Stage Fully Adjustable6 - 8 ozs Pull Weight

FIELD TARGET TRIGGER

1/16 & 2mmallen keys supplied