timing & data technical report ver 7.2 1. timing & data technical report is required for all...
TRANSCRIPT
TIMING & DATA TECHNICAL REPORT TIMING & DATA TECHNICAL REPORT ver 7.2ver 7.2
1
Timing & Data Technical Report is required for all scored events – USSA & FIS. It is also required for USSA non-scored Championship events, e.g. U12 Championships, Masters Championships.
2
(This part of the presentation addresses the paper copy of the report which can only be used for non-FIS events.)
EVENT IDENTIFIERSEVENT IDENTIFIERS
USSA Transmittal #: Alpha character + 4 numbers assigned by USSA and used only for non-FIS events.
FIS CODEX #:FIS events use 4 numbers assigned by FIS; FIS-supplied software must be used to generate the report and to use the FIS online reporting system. Software also generates a PDF copy for signatures/required packets. (Details at end of presentation.)
3
4
Event:* Type of race: DH, SL, GS, SG, AC
Gender:* Ladies or Men
*“Check Boxes” enabled!
Location: As listed on website
Event Name: As listed on website
Date: Actual date of event
Equipment IdentifiersEquipment Identifiers
Sys Timer ASys Timer BStart GateFinish Cell AFinish Cell B
•Brand Name•Model or Type•Serial Number•Homologation #
5
This information must be accurate; equipment must be currently homologated!
Timekeeping Equipment
BrandModelSerial #Homol. #
ModelSerial #Homol. #
TAG HEUERCP 5402004TAG.070T.08
Minitimer HL4401015TAG.076T.09
6
Start Gate BrandModelSerial #Homol. #
TAG HEUERHL 7-1996TAG.S54.03
7
Photo Cells
BrandModelSerial #Homol. #
ModelSerial #Homol. #
TAG HEUERHL 2-32121TAG.L49T.10
HL 2-32122TAG.L49T.03
8
SOFTWARE / RESULTS VERIFICATIONSOFTWARE / RESULTS VERIFICATION
9
Brand: Name of Software
Version: Version used by timing & results computers
Date: Date of version used – not date of event
Results = Tapes: Confirmation that assigned times = printed timing tapes
CONNECTIONSCONNECTIONS
How do we communicate signals/data from Start to Finish?
How is voice communication handled between Start and Finish?
•Cable
•Radio
•Snowmobile
•Ski Lift
•Skier
•??
10
POWER ON & SYNCHRONIZATIONPOWER ON & SYNCHRONIZATION
At what time is the run scheduled to start?– Is there a rule about Synchronization?
– What is the minimum recommended warm- up time?– Why do you have to wait to synchronize?
11
SYNCHRONIZATION AND SYNC + 1 MINUTESYNCHRONIZATION AND SYNC + 1 MINUTE
• Are Systems A and B synchronized?– How close are they?
• What is the maximum difference acceptable?
• What about Hand Sync (Manual Timekeeping)?
12
FIRST COMPETITOR QUALITY CHECKFIRST COMPETITOR QUALITY CHECK
•Is Net Time the same as A time-of-day difference?– How close are they?– Does Net Time agree with Official Results?
•What is the B time-of-day difference?– Discuss the difference?
•What about Hand Sync (Manual Timekeeping)?
13
LAST COMPETITOR QUALITY CHECKLAST COMPETITOR QUALITY CHECK
•Is Net Time the same as A time-of-day difference?
– How close are they?– Does Net Time agree with Official Results?
•What is the B time-of-day difference?
– Discuss the difference?
•What about Hand Sync (Manual Timekeeping) ?
14
FIRST RUN SUMMARYFIRST RUN SUMMARY
•Why do we show Best run-time?•Why do we show the Bib #?
15
SECOND RUN SYNC +1 MINUTESECOND RUN SYNC +1 MINUTE
- Are Systems A & B synchronized?
- Do the rules require re-synchronization between 1st & 2nd Runs?
- Why do you think there was no Hand re-sync?
16
SECOND RUN SUMMARYSECOND RUN SUMMARY
Notice First and Last racer data quality!
17
RACE SUMMARYRACE SUMMARY
Were all Results from system A? If you answer “NO”, you must list any or all bib numbers – in all runs – where an assigned time was obtained from any system other than system A (indicate run).
WHY? List the reason: Batteries Snow obscuration Wire breakPhotocell alignment Other? (describe)
Data source for replacement system A time (resp. ACR 611.2.1)? What did you use? System B System C Manual
NOTE: If Replacement Time (EET) calculated, include calculation worksheet(s) with this form. (Sent to TWG representative.)
18
RACE COMMENTSRACE COMMENTS
– What comments might or should be shown?
– What should NOT be shown?
19
CERTIFICATIONCERTIFICATION
We certify that the timing and calculations of this event adhered to the USSA rules.
•Any discussion on this?
•Are we through now?
20
SIGN OFFSIGN OFF
•Chief T & C– Printed Name and NAT– Telephone nr.– Email address– USSA #– SIGNATURE
•Technical Delegate– Printed Name and NAT– Telephone nr.– Email address– USSA #– SIGNATURE
21
COMPLETED TDTRCOMPLETED TDTR
22
- The Chief of Timing & Calculations is responsible for the accurate completion of this form.
- The Technical Delegate is responsible for verifying the accuracy of the data.
- Both officials must sign the form as their confirmation of the accuracy of the timing for the event.
- A TDTR is required for ALL scored events.- A TDTR is required for ALL non-scored
Championship events; e.g. U12, U14 and Masters Championships.
ONLINE TDTRONLINE TDTR• Software that allows online filing is available• Data requirements are identical to paper form • Its use is required for all FIS events: Depending on
connection, download time can vary – DOWNLOAD, INSTALL AND TEST IN ADVANCE OF YOUR EVENT!
• It is available in (Windows, MacOS & Linux)• Available for review/download at: ftp://ftp.fisski.ch/Software/Programs/TimingReport/AL/ Race result XML and TDTR XML files must be submitted prior to
filing online TD Report!
23
TIMING & DATA TECHNICAL REPORT SOFTWARE *TIMING & DATA TECHNICAL REPORT SOFTWARE *Versions 2.1.2 / 2.1.3Versions 2.1.2 / 2.1.3
*Please verify you are using the most current version of the software!
24
(Edited XML from prior season’s event used for this presentation.)
The new TDTR software program can be found On the FIS FTP site.
25
Select OS & Download
TDTR SOFTWARE INSTALLATION
26
Select Option & Continue
TDTR SOFTWARE, Step 2
27
Select Option & Continue
TDTR SOFTWARE, Step 3
28
Accept
Change
or
and Continue
TDTR SOFTWARE, Step 4
29
Select Storage Location
Continue
TDTR SOFTWARE, Step 5
30
Select Options
Continue
TDTR SOFTWARE, Step 6
31
Go Back to Change Preferences, Install or Cancel
Verify Preferences
TDTR SOFTWARE, Step 7
32
Finish Installation & Launch Software
The Software: P1.The Software: P1.
33
Event Information as listed on applicable website for level of event
Officials’ names as listed on applicable website for level of event (name on FIS site may be different than that listed on USSA site, e.g. Randy Rogers on FIS and Randall Rogers on USSA!)
34
First-time use requires loading list of homologated timing devices
35
Start online update
36
Note date/time for Update
37
Prompt for new version after initial installaton
New Version Information (Uninstall/Re-install may be required.)
OPTIONS/PREFERENCES: TimekeeperOPTIONS/PREFERENCES: Timekeeper
38
Insert ALL “Timekeeper” Defaults & Save
OPTIONS/PREFERENCES/TIMING DEVICESOPTIONS/PREFERENCES/TIMING DEVICES
39
Select “Timing Devices” Default Choices & Save
Check for device updates!This is not the same function as “NEW VERSION”
OPTIONS/PREFERENCES: Program OptionsOPTIONS/PREFERENCES: Program Options
40
Insert ALL “Program Options” Default Choices & Save
Online Timing and Data Technical ReportOnline Timing and Data Technical Report
41
TIMEKEEPING EQUIPMENTTIMEKEEPING EQUIPMENT
42
Dropdown boxes for equipment brand and model selections
You must insert Serial Numbers!
Homologation number automatically inserted
Additional selections & continue(Select “Other” if your software not listed.)
Hardware Dropdown SelectionsHardware Dropdown Selections
43
Device and Connection InformationDevice and Connection Information
44
Select Your ConnectionsSelect Your Connections
45
Drop down boxes make it simple!
Technical Timing InformationTechnical Timing Information
46
Prior to “Finish”, Software will prompt for all error corrections!
Summary of Race:Summary of Race:All times from system “A”? YES
47
Summary of Race:Summary of Race: all times from system “A”? NO
48
Can add / delete / select, as needed.
“NO” is selected; information required.
If “NO”, enter Bib, Run & Select the Reason
49
Drop-down Selections make it easy!
“Other” allows you to key in a reason.
“Add to List” inserts your keyed data.
Followed rules?
OUTPUTS: OUTPUTS: SAVE PDF / VIEW XML / SAVE XML and EMAIL
50
Select “Output”
Select your option – “Save PDF” allows for TD’s review.
Option: SAVE “PDF” Option: SAVE “PDF” WILL SAVE TO LOCATION OF YOUR CHOOSING
51
PRINT “PDF” PRINT “PDF” Saved as: 2015AL6623TR
52
Must be signed by Chief of Timing & Technical Delegate
Note date & time stamp
Print for TD’s review, signature and race result document packet copying
Option: “VIEW XML”Option: “VIEW XML”
53
This is the format of the file you will be transmitting to FIS.
Option: SAVE “XML”Option: SAVE “XML”WILL SAVE THE TRANSMISSION FILE TO LOCATION OF YOUR CHOOSING
54
2015AL6623TR.xml
SELECT “AUTO-SEND” SELECT “AUTO-SEND” (Preferred Option)(Preferred Option)
55
More data required!
Loading default information in “Program Options” will eliminate necessity to enter email address.
ENTER DATA & AUTO-SEND or…ENTER DATA & AUTO-SEND or…
56
SAVE XML and…SAVE XML and…
57
You will be prompted for a “save” location!
Attach “saved” file and e-mail to: Attach “saved” file and e-mail to: [email protected]@fisski.ch
58
SUBMITTING THE TDTR XML FILE SUBMITTING THE TDTR XML FILE • The TDTR XML and the RACE RESULT XML files must be submitted before the TD
submits his online TD Report.
• After all the data is entered in the software:
- TDTR must be saved as PDF and printed/signed for result packets
- TDTR may be viewed as XML
- TDTR must either be auto sent or saved as XML
- Saved XML TDTR must be attached to an email and sent to
• Errors? Corrections can be made and the XML can be resent
NOTE: FIS results will not be scored to the FIS Points List until the TDTR XML file & FIS TD Report are submitted.
59
WHAT ABOUT NON-FIS EVENTS?• A TDTR is required for all USSA-scored non-FIS events
• A TDTR is required for all USSA non-scored Championship events, e.g. YSL, U10, U12 Junior Championships, Masters Championships, etc.
• Either the original paper copy USSA TDTR can be prepared or the FIS TDTR software can be used to produce a PDF report, as required, for non-FIS events.
• FIS TDTR software may be used for non-FIS events (FIS logo instead of USSA logo is a non-
issue.) - “National Race Code” is used for USSA Transmittal # (alpha character + 4-digit number) - “Category” must be selected; JUN-Junior or CHI-Children are acceptable - “Race Codex” is left blank.
• The TDTR XML file must not be submitted to USSA’s autoscoring system as USSA is not currently set up to accept the TDTR XML file
The TDTR for a non-FIS event must never be submitted to FIS!
60
USSA Race Transmittal CodeInclude ALPHA designator with assigned USSA Race Code
U for USSA scored, N for USSA non-scored,
M for Masters, O (text not number) for Other
For non-FIS events: Select “Category”:
“JUN-Junior” or “CHI-Children”
“Race Codex” is left blank; (no error message will be generated)
TDTR FOR NON-FIS EVENT
62
“U” for “USSA SCORED” + 4-digit USSA Transmittal number
Document must be printed/signed and included in scanned/PDF electronic or paper copy non-FIS Race Result Document Packets, as required.
“JUN - Junior Race” selected; this and “CHI -Children” were only selections that seem to apply for non-FIS events
Thank You For Your Attention!This is an upgraded presentation. It has taken advantage of the work done by many Alpine
Officials and we are grateful for their contributions.
The intention was to build a vehicle that can be used for explaining the intricacies of the TDTR as well as for updating Timing Chiefs and Technical Delegates.
This presentation is dedicated to Allen Church and includes a special “THANK YOU” for his many years of service to the USSA and the FIS Alpine Officials’
community.
Allen “The Pope” Church has been a valuable mentor and is a valued friend. He encouraged us to do our best and helped us to be better than we thought possible!
63