POWER SUPPLY

DC O

UT

+

-

TLD-DMU-010-2-18

100 Boxart Street, Suite 230 Rochester, NY 14612

585-697-0093Fax: 585-663-1432

www.thelightingdivision.com

Power SuppliesCerti�ied to

ENERGY STAR

Life In LED Light

When used with any of our 15v or 24v DC regulated low voltage power supplies, the dimmer’s range can be smoothly adjusted from 100% full brightness down to o� by using a compatible 0-10v wall dimmer switch.

Please contact The Lighting Division if you have any questions regarding its use or installation.

TLD-DMU-010 Dimmer ControllerTLD-DMU-010 Dimmer Controller

Made in USAMade In USAof U.S. and

imported parts

Size 3.8” x 1.7” x .8”

Power 12v - 24v DC / 8 amp

Max Load 12v/96w, 15v/120w, 24v/192w

Dimming 100% - 0%

BLAC

K

RED

BLAC

K

RED

Installation:When installing the Dimmer Control, please take note of the polarity label on the cover. The label points out which end is connected to the LED lighting, and which end is connected to the power supply.

1. Connect red (+) wire from power supply to the red side of the terminal labeled “+ IN”.

2. Connect black (-) wire from power supply to the white side of the terminal labeled “ - IN”.

3. Connect wire from the red side of the dimmer terminal labeled “+ OUT” to the red side of the terminal on the light �xture.

4. Connect wire from the white side of the dimmer terminal labeled “ - OUT” to the white side of the terminal on the light �xture.

5. Connect purple wire from the wall switch to the 0-10 purple terminal on the TLD-DMU-010.

6. Connect the gray wire from the wall switch to the other 0-10 terminal on the TLD-DMU-010.

7. Mounting the Dimmer Control can be accomplished with a suitable double sided tape, or by mechanically fastening with screws through the slots on either side of the case.

PURPLE

FROM 0-10VWALL SWITCH

GREY

2 Year Limited Warranty