touchstone tg1672g/na telephony gateway user's · pdf filetouchstone ®tg1672 telephony...

Click here to load reader

Post on 03-Aug-2018

213 views

Category:

Documents

0 download

Embed Size (px)

TRANSCRIPT

  • Touchstone TG1672 Telephony Gateway

    Users Guide

    Get ready to experience the Internets express lane! Whether youre checking outstreaming media, downloading new software, checking your email, or talking withfriends on the phone, the Touchstone TG1672 Telephony Gateway brings it all to youfaster and more reliably. All while providing toll quality Voice over IP telephone ser -vice and both wired and wireless connectivity. It also provides a Lithi um-Ion bat-tery backup to provide continued telephone service during power outages.

    The Touchstone Telephony Gateway provides four Ethernet connections for use asthe hub of your home/office Local Area Network (LAN). The Telephony Gatewayalso provides 802.11a/b/g/n wireless connectivity for enhanced mobility and ver-satility. In addition, the Telephony Gateway provides for up to two separate lines oftelephone service. The Telephony Gateway also offers integrated MoCA 1.1 homenetworking providing Internet access and transfer of multimedia content betweendevices over coaxial cable in the home.

    Installation is simple and your cable company will provide assistance to you for anyspecial requirements. The links below provide more detailed instructions.

    Safety Requirements

    Getting Started

    Battery Installation and Removal

    Installing and Connecting Your Telephony Gateway

    Configuring Your Ethernet Connection

    Using the Telephony Gateway

    Troubleshooting

    Glossary

  • Export Regulations

    This product may not be exported outside the U.S. and Canada without U.S. Department of Commerce, Bureau of Export Admin istration au-thorization. Any export or re-export by the purchaser, directly or indirectly, in contravention of U.S. Export Adminis tration Regulation is prohib-ited.

    ARRIS Enterprises, Inc. 2013 All rights reserved. No part of this publication may be reproduced in any form or by any means or used to makeany derivative work (such as translation, transformation, or adaptation) without written permission from ARRIS Enterprises, Inc. (ARRIS).ARRIS reserves the right to revise this publication and to make changes in content from time to time without obligation on the part of ARRIS toprovide notification of such revision or change.

    ARRIS provides this guide without warranty of any kind, implied or expressed, including, but not limited to, the implied warranties of mer-chantability and fitness for a particular purpose. ARRIS may make improvements or changes in the product(s) described in this manual at anytime. The capabilities, system requirements and/or compatibility with third-party products described herein are subject to change without no-tice.

    ARRIS and the ARRIS logo are all trademarks of ARRIS Enterprises, Inc. Other trademarks and trade names may be used in this document torefer to either the entities claiming the marks and the names of their products. ARRIS disclaims proprietary interest in the marks and names ofothers.

    Protected under one or more of the following U.S. patents: 7,031,435, 7,916,744. Other patents pending.

    Release 16 Standard 1.0 October 2013

  • Safety Requirements

    ARRIS Telephony Gateways comply with the applicable requirements for perform-ance, construction, labeling, and information when used as outlined below:

    CAUTIONRisk of shock

    Mains voltages inside this unit. No user serviceable parts inside. Referservice to qualified personnel only!

    CAUTIONPotential equipment damagePotential loss of service

    Connecting the Telephony Gateway to existing telephone wiring shouldonly be performed by a professional installer. Physical connections tothe previous telephone provider must be removed and the wiring mustbe checked; there must not be any voltages. Cancellation of telephoneservice is not adequate. Failure to do so may result in loss of serviceand/or permanent damage to the Telephony Gateway.

    CAUTIONRisk of explosion

    Replacing the battery with an incorrect type, heating a battery above75C, or incinerating a battery, can cause product failure and a risk offire or battery explosion. Do not dispose of in fire. Recycle or disposeof used batteries responsibly and in accordance with local ordinances.

    The Telephony Gateway is designed to be connected directly to a telephone.

    Connecting the Telephony Gateway to the homes existing tele phone wiringshould only be performed by a professional in staller.

    Do not use product near water (i.e. wet basement, bathtub, sink or near aswimming pool, etc.), to avoid risk of electrocu tion.

    Do not use the telephone to report a gas leak in the vicinity of the leak.

    Touchstone TG1672 Telephony Gateway Users Guide

    SafetyGettingStarted

    BatteryInstallation Installation

    EthernetConfiguration Usage Troubleshooting Glossary

    3

  • The product shall be cleaned using only a damp, lint-free, cloth. No sol-vents or cleaning agents shall be used.

    Do not use spray cleaners or aerosols on the gateway.

    Avoid using and/or connecting the equipment during an electri cal storm, toavoid risk of electrocution.

    Do not locate the equipment within 6 feet (1.9 m) of a flame or ignitionsource (i.e. heat registers, space heaters, fireplaces, etc.).

    Use only power supply and power cord included with the equip ment.

    Equipment should be installed near the power outlet and should be easily accessible.

    The shield of the coaxial cable must be connected to earth (grounded) at theentrance to the building in accordance with applicable national electrical in-stallation codes. In the U.S., this is required by NFPA 70 (National ElectricalCode) Article 820. In the European Union and in certain other countries,CATV instal lation equipotential bonding requirements are specified in IEC60728-11, Cable networks for television signals, sound signals and interac-tive services, Part 11: Safety. This equipment is in tended to be installed inaccordance with the requirements of IEC 60728-11 for safe operation.

    If the equipment is to be installed in an area serviced by an IT power linenetwork, as is found in many areas of Norway, spe cial attention should begiven that the installation is in accor dance with IEC 60728-11, in particularAnnex B and Figure B.4.

    In areas of high surge events or poor grounding situations and areas proneto lightning strikes, additional surge protection may be required (i.e.PF11VNT3 from American Power Conver sion) on the AC, RF, Ethernet andPhone lines.

    When the Telephony Gateway is connected to a local computer through Eth-ernet cables, the computer must be proper ly grounded to the building/res-idence AC ground network. All plug-in cards within the computer must beproperly installed and grounded to the computer frame per the manufac-turers specifications.

    Ensure proper ventillation. Position the Telephony Gateway so that air flowsfreely around it and the ventillation holes on the unit are not blocked.

    Touchstone TG1672 Telephony Gateway Users Guide

    SafetyGettingStarted

    BatteryInstallation Installation

    EthernetConfiguration Usage Troubleshooting Glossary

    4

  • Do not mount the Telephony Gateway on surfaces that are sensitive to heatand/or which may be damaged by the heat generated by the modem, itspower supply, or other accessories.

    FCC Part 15

    This equipment has been tested and found to comply with the requirements for aClass B digital device under Part 15 of the Federal Communications Commission(FCC) rules. These requirements are intended to provide reasonable protectionagainst harmful interference in a residential installation. This equipment generates,uses and can radiate radio frequency energy and, if not installed and used in ac-cordance with the instructions, may cause harmful interference to radio communi-cations. However, there is no guarantee that interference will not occur in aparticular installation. If this equipment does cause harmful interference to radio ortelevision reception, which can be determined by turning the equipment off and on,the user is encouraged to try to correct the interference by one or more of the fol-lowing measures:

    Reorient or relocate the receiving antenna.

    Increase the separation between the equipment and receiver.

    Connect the equipment into an outlet on a circuit different from that to whichthe receiver is connected.

    Consult the dealer or an experienced radio/TV technician for help.

    Warning: Changes or modifications to this equipment not expressly approved bythe party responsible for compliance could void the users authority to operate theequipment.

    RF Exposure

    This equipment complies with FCC radiation exposure limits set forth for an uncon-trolled environment. This equipment should be installed and operated with mini-mum distance of 7.9 inches (20cm) between the radiator and your body. Thistransmitter must not be co-located or operating in conjunction with any other an-tenna or transmitter.

    Touchstone TG1672 Telephony Gateway Users Guide

    SafetyGettingStarted

    BatteryInstallation Installation

    EthernetConfiguration Usage Troubleshooting Glossary

    5

  • Industry Canada Compliance

    Under Industry Canada regulations, this radio transmitter may only operate usingan antenna of a type and maximum (or lesser) gain approved for the transmitterby Industry Canada. To reduce potential radio interference to other users, the an-tenna type and its gain should be so chosen that the equivalent isotropically radi-ated power (e.i.r.p.) is not more than that necessary for successful communication.

    This device complies with Industry Canada license-exempt RSS standard(s). Oper-ation is subject to the following two conditions: (1) this device may not cause in-terference, and (2

View more