training session.docx

7/28/2019 TRAINING SESSION.docx

1/8

ARNITA SEZ CONSULTANTS PVT LTD

REPORT ON TRAINING SESSION - 1

STRUCTURAL ENGINEERING

Prepared by- Nilesh sutar

DATE:- 14 APRIL 2012

GUIDE:- MR. CHANDE SIR

Salient features of training:-

1] Locations of column and shear wall on structural model

2] Load combinations and loading calculations.

3] Spacing and Sizes of Column

4] Load carrying capacity of column and percentage of steel utilized

5] Design forces for earthquake and pt used in design

6] Explanatory commands Reducible live load in Etab, Material list


2/8


TRAINING SESSION - 2





AGENDA FOR TRAINING SESSION 2

1. What should be the effective length of column2. Additional moment method of column design3. Development of interaction diagram for biaxial column4. Reduction of column size5. Design of column for highrise building special for wind load6. Design of short column for earthquake load7. Tapered or Geometrical shape vertical member design


3/8








1] Design of beam for governing condition (Shear force)

2] Design of Isolated footing governing criteria shear force

Pt calculations , design for shear and check for bending moment

3] Economical design of footing - shear capacity , steel ratio used for footing

Limiting ratio of steel- total quantity of steel, concrete.

Correction on footing design excel sheet

4] PEB structure columns and footings, hinge locations in column

5] Local axis and Global axis of members in ETAB and Staad Pro


4/8





DATE:- 12 MAY 2012



1. Discussion on IS 1893-20022. Location and Design of Shear wall

REVISED AGENDA FOR TRAINING SESSION 3

1. Biaxial footing design by Tengs chart2. Chimney Design3. Water tank Design


5/8





DATE:- 12 MAY 2012



1] Moment consideration in footing design

2] Modulus of subgrade reaction

3] Deflection of footing

4] Loss of contact of footing

5] Factor of safety against overturning

6] Tengs chart

7] Chimney design- factors to be considered in chimney design

8] Water tank design- Behavior of water tank, stresses in water tank

Design methods of water tank.


6/8





DATE:- 26 MAY 2012


AGENDA FOR TRAINING SESSION A

1. Review of last training session.

2. Flow of forces.

3. Column Design

4. Grid Beam Design for large floor area.


7/8





DATE:- 25-08- 2012



1. Review of last training session.

2. Introduction to SAFE software.

3. Project review Zydus Hospira design of pile raft.

Zydus Hospira having issue that some of the piles are failed in

Dynamic test. Also site condition such that space available for isolated

Footing very less. In such case it is necessary to consider the pile

Capacity given in pile dynamic test report.


8/8





DATE:- 25-08- 2012


Salient features of training session:-

1] Introduction to SAFE 12 Software.

2.] Modelling and analysis in SAFE software.

3.] Study of Zydus Hospira project:

Design of pile raft in SAFE, In this reduced capacities of piles given by Pile dynamic test

Report is utilized for calculation of pile raft. From Modulus of subgrade of soil and spring

Stiffness of pile area of pile raft is calculated.

Design of pile raft is done using run analysis and design command in SAFE software.

training session.docx

Documents