u3e-l11 march 17, 2008 classwork cut with band saw cut with scissors cut with hacksaw
TRANSCRIPT
![Page 1: U3e-L11 March 17, 2008 CLASSWORK CUT WITH BAND SAW CUT WITH SCISSORS CUT WITH HACKSAW](https://reader036.vdocument.in/reader036/viewer/2022081603/56649f555503460f94c78e15/html5/thumbnails/1.jpg)
U3e-L11
March 17, 2008
CLASSWORK
CUT WITH BAND SAW
CUT WITH BAND SAW
CUT WITH SCISSORS
CUT WITH H
ACKSAW
![Page 2: U3e-L11 March 17, 2008 CLASSWORK CUT WITH BAND SAW CUT WITH SCISSORS CUT WITH HACKSAW](https://reader036.vdocument.in/reader036/viewer/2022081603/56649f555503460f94c78e15/html5/thumbnails/2.jpg)
Note: Use a dowel to eject the waste from the pipe tool.
Make the ½” diameter holes with the pipe tool.
Motor Design, Design Drawings, and Lesson
Courtesy of Fred Nastvogel
![Page 4: U3e-L11 March 17, 2008 CLASSWORK CUT WITH BAND SAW CUT WITH SCISSORS CUT WITH HACKSAW](https://reader036.vdocument.in/reader036/viewer/2022081603/56649f555503460f94c78e15/html5/thumbnails/4.jpg)
Orthogonal Views of ProductSKETCH and LABEL
Motor Design, Design Drawings, and Lesson
Courtesy of Fred Nastvogel
![Page 5: U3e-L11 March 17, 2008 CLASSWORK CUT WITH BAND SAW CUT WITH SCISSORS CUT WITH HACKSAW](https://reader036.vdocument.in/reader036/viewer/2022081603/56649f555503460f94c78e15/html5/thumbnails/5.jpg)
U3e-L8
Orthogonal Views of ProductSKETCH and LABEL
Motor Design, Design Drawings, and Lesson
Courtesy of Fred Nastvogel
![Page 6: U3e-L11 March 17, 2008 CLASSWORK CUT WITH BAND SAW CUT WITH SCISSORS CUT WITH HACKSAW](https://reader036.vdocument.in/reader036/viewer/2022081603/56649f555503460f94c78e15/html5/thumbnails/6.jpg)
• Draft the given shapes on paper.
• Be precise with your measurements and your drawings.
• Cut out shapes and discard all paper scraps.
CLASSWORK
2 DRAWINGS2 DRAWINGS 1 DRAWING
Diameter=¼”
Motor Design, Design Drawings, and Lesson
Courtesy of Fred Nastvogel