under water wireless communication
DESCRIPTION
Underwater acoustic communication is a technique of sending and receiving message below water.[1] There are several ways of employing such communication but the most common is using hydrophones. Under water communication is difficult due to factors like multi-path propagation, time variations of the channel, small available bandwidth and strong signal attenuation, especially over long ranges. In underwater communication there are low data rates compared to terrestrial communication, since underwater communication uses acoustic waves instead of electromagnetic waves.TRANSCRIPT
![Page 1: under water wireless communication](https://reader038.vdocument.in/reader038/viewer/2022102616/559ecc491a28abb6338b470b/html5/thumbnails/1.jpg)
SEMINAR REPORT ON
UNDERWATER WIRELESS COMMUNICATION
SESSION – 2014-15
ELECTRONICS & COMMUNICATION ENGG.
DHEERESH KUMAR
B.TECH. 4RD YEAR
ROLL NO. 110600102008
SURAJMAL LAXMIDEVI SAWARTHIA EDUCATIONAL TRUST &
GROUP OF INSTITUTIONS
![Page 2: under water wireless communication](https://reader038.vdocument.in/reader038/viewer/2022102616/559ecc491a28abb6338b470b/html5/thumbnails/2.jpg)
INTRODUCTION
Underwater wireless communication is the wireless communication in which acoustic signals (waves) carry digital information through an underwater channel. Electromagnetic waves are not used as they propogate over short distances. Over the past decades, heavy cables were used to establish a high speed communication between remote end and the surface. To overcome such difficulties, underwater wireless communication has come into existence The propagation speed of acoustic signals in water is typically 1500 m/s.
It cannot rely on the Global Positioning System (GPS).
![Page 3: under water wireless communication](https://reader038.vdocument.in/reader038/viewer/2022102616/559ecc491a28abb6338b470b/html5/thumbnails/3.jpg)
NECESSITY OF UNDERWATER WIRELESS
COMMUNICATION
Wired underwater is not feasible in all
situations as shown below-:
Temporary experiments
Breaking of wires
Significant cost of deployment
Experiment over long distances.
To cope up with above situations, we require
underwater wireless communication.
![Page 4: under water wireless communication](https://reader038.vdocument.in/reader038/viewer/2022102616/559ecc491a28abb6338b470b/html5/thumbnails/4.jpg)
FACTORS INFLUENCING ACOUSTIC
COMMUNICATION
Path loss: Due to attenuation and geometric
spreading.
Noise: Man-made noise and ambient
noise(due to hydrodynamics)
Multi-path propogation
High propogation delay
Doppler frequency spread.
![Page 5: under water wireless communication](https://reader038.vdocument.in/reader038/viewer/2022102616/559ecc491a28abb6338b470b/html5/thumbnails/5.jpg)
HARDWARE PLATFORM INTERFACES
Sensor Interface:
Must develop common interface with different
sensors (chemical, optical, etc.) and
communication elements (transducer) .
Wide (constantly changing) variety of sensors,
sampling strategies
Communication Interface:
Amplifiers, Transducers
Signal modulation
![Page 6: under water wireless communication](https://reader038.vdocument.in/reader038/viewer/2022102616/559ecc491a28abb6338b470b/html5/thumbnails/6.jpg)
Hardware:
Software Defined Acoustic Modem (SDAM)
Reconfigurable hardware known to provide,
flexible, high performance implementations for
DSP applications
![Page 7: under water wireless communication](https://reader038.vdocument.in/reader038/viewer/2022102616/559ecc491a28abb6338b470b/html5/thumbnails/7.jpg)
ACOUSTIC MODEM
Employ advanced modulation scheme and channel equalization for improved signal to noise ratio.
Employ high performance error detection and correction coding scheme which reduces bit error rate to less than 10-7
Parts of an acoustic modem:
DSP Board
AFE(Analog Front End) Board
DC/DC Converter
![Page 8: under water wireless communication](https://reader038.vdocument.in/reader038/viewer/2022102616/559ecc491a28abb6338b470b/html5/thumbnails/8.jpg)
DATA TRANSMISSION IN MODEM
When no data is being transmitted, the
modem stays in sleep mode, it periodically
wakes up to receive possible data being
transmitted by far end modem. This results in
low power consumption. Similarly when the
data is to be transmitted , the modem
receives data from its link in sleep mode and
then switches to transmit mode and transmit
the data.
![Page 9: under water wireless communication](https://reader038.vdocument.in/reader038/viewer/2022102616/559ecc491a28abb6338b470b/html5/thumbnails/9.jpg)
ADVANCED MODEMS AVAILABLE
![Page 10: under water wireless communication](https://reader038.vdocument.in/reader038/viewer/2022102616/559ecc491a28abb6338b470b/html5/thumbnails/10.jpg)
UNDERWATER ACOUSTIC SENSOR
NETWORKS (UW-ASN)
Group of sensors and vehicles deployed
underwater and networked via acoustic
links, performing collaborative tasks.
Equipment
Autonomous Underwater Vehicles (AUVs)
Underwater sensors (UW-ASN)
![Page 11: under water wireless communication](https://reader038.vdocument.in/reader038/viewer/2022102616/559ecc491a28abb6338b470b/html5/thumbnails/11.jpg)
UW-ASN COMMUNICATION ARCHITECTURE
![Page 12: under water wireless communication](https://reader038.vdocument.in/reader038/viewer/2022102616/559ecc491a28abb6338b470b/html5/thumbnails/12.jpg)
UW-ASN COMMUNICATION ARCHITECTURE
![Page 13: under water wireless communication](https://reader038.vdocument.in/reader038/viewer/2022102616/559ecc491a28abb6338b470b/html5/thumbnails/13.jpg)
ADVANTAGES
Can be used to provide early warnings of
tsunamis generated by undersea
earthquakes.
It avoids data spoofing.
It avoids privacy leakage.
Pollution monitoring.
![Page 14: under water wireless communication](https://reader038.vdocument.in/reader038/viewer/2022102616/559ecc491a28abb6338b470b/html5/thumbnails/14.jpg)
APPLICATIONS
Seismic monitoring.
Pollution monitoring
Ocean currents monitoring
Equipment monitoring and control
Autonomous Underwater Vehicles (AUV)
Remotely operated vehicle(ROV)
Acoustic navigation technology for multiple AUVs.
Solar Powered AUVs
![Page 15: under water wireless communication](https://reader038.vdocument.in/reader038/viewer/2022102616/559ecc491a28abb6338b470b/html5/thumbnails/15.jpg)
•SEARCH AND RESCUE MISSION
![Page 16: under water wireless communication](https://reader038.vdocument.in/reader038/viewer/2022102616/559ecc491a28abb6338b470b/html5/thumbnails/16.jpg)
DISADVANTAGES
Battery power is limited and usually batteries can not be recharged easily.
The available bandwidth is severely limited.
Underwater sensors are prone to failures because of fouling, corrosion, etc.
Channel characteristics including long and variable propagation delays.
Multipath and fading problems.
High bit error rate.
![Page 17: under water wireless communication](https://reader038.vdocument.in/reader038/viewer/2022102616/559ecc491a28abb6338b470b/html5/thumbnails/17.jpg)
CONCLUSION
The aim of this is to build a acoustic
communication.
This is not only the way for underwater
communication.
By using optical waves which offers higher
throughput (Mbps) over short distances (up
to about 100 m) .
![Page 18: under water wireless communication](https://reader038.vdocument.in/reader038/viewer/2022102616/559ecc491a28abb6338b470b/html5/thumbnails/18.jpg)
THANK YOU