v-twin audio, vtram15 · 2019. 11. 4. · v-twin audio, vtram15 1. remove outer fairing as per hd...

1
V-TWIN AUDIO, VTRAM15 1. Remove outer fairing as per HD manual (contact us if you need instructions). 2. To install VTRAM15R or L, remove the radio (4 screws) and connectors. Remove corresponding (left, right or both) speaker pods. 3. Install with tabs facing up, see photo below. Align with 2 holes underneath the radio support bracket's "WINGS" found on each side. Use a 5/32" ball end socket to reach the bolt heads & a 7/16" wrench to hold each nut. "MAKE SURE PLATE SITS ABOVE THE GAUGE'S WIRE HARNESS"! 4. Install amplifier as shown in photo below. The amp's speaker plug & switches should be facing you as you stand in front of the bike. Above: view of amp plate orientation, from front of bike

Upload: others

Post on 27-Feb-2021

3 views

Category:

Documents


0 download

TRANSCRIPT

Page 1: V-TWIN AUDIO, VTRAM15 · 2019. 11. 4. · V-TWIN AUDIO, VTRAM15 1. Remove outer fairing as per HD manual (contact us if you need instructions). 2. To install VTRAM15R or L, remove

V-TWIN AUDIO, VTRAM15

1. Remove outer fairing as per HD manual (contact us if you need instructions).

2. To install VTRAM15R or L, remove the radio (4 screws) and connectors. Remove corresponding (left, right or both) speaker pods.

3. Install with tabs facing up, see photo below. Align with 2 holes underneath the radio support bracket's "WINGS" found on each side. Use a 5/32" ball end socket to reach the bolt heads & a 7/16" wrench to hold each nut. "MAKE SURE PLATE SITS ABOVE THE GAUGE'S WIRE HARNESS"!

4. Install ampli�er as shown in photo below. The amp's speaker plug & switches should be facing you as you stand in front of the bike.

Above: view of amp plate orientation, from front of bike