Ventac QT Acoustic Pump Jacket

INSTALLATION GUIDE

7 easy steps to installing your acoustic pump jacket

June 2014

© Ventac 2014

Ventac QT Acoustic Pump Jacket

Designed to combat operational noise

from domestic booster pumps

Easily installed this solution provides and

effective way to eliminate annoying pump noise

© Ventac 2014

What You Will Receive

2 Piece Acoustic Jacket

Anti-Vibration Mat Multi-Hole Saw

© Ventac 2014

Position the rubber vibration mat

underneath the booster pump.

© Ventac 2014

Step 1 – Position

© Ventac 2014

Step 2 – Measure

Carefully measure pipe distance from

wall and floor.

© Ventac 2014

Wall

Step 3 – Mark

Mark distances on pump jacket for

drilling, measuring to the centre of the hole location for the pipes.

© Ventac 2014

Step 4 – Drill

Carefully drill out locations for pipes using the supplied

hole saw bit.

© Ventac 2014

Step 5 – Cut

Using a standard scissors, cut the

jacket to allow for pipe access.

© Ventac 2014

Step 6 – Fit

Position the jacket over the pump,

positioning pipes accordingly.

© Ventac 2014

Step 7 – Assemble

Fit the lid of the jacket ensuring all

velcro flaps are tightly secured.

© Ventac 2014

Important Point To Note

Certain pump models require additional ventilation holes as they are air-cooled instead of water-cooled. This involves drilling extra holes as shown below that allow additional circulation.

© Ventac 2014

The pump jacket has been designed for use with Grundfos, Salamander and Monsoon booster pumps

Drill 2 holes here (at base where motor is)

& 2 holes here (close to the top)

The Completed Solution

© Ventac 2014

Congratulations!You have installed your new

acoustic booster pump jacket

Ventac

Fitzwilliam House

Blessington

Wicklow

045 851500

info@ventac.com