WAVE

COLLLECTIONN

Uovo(CG 01)

Uovo (CG 01)

Marron(CG 07)

Perla(CG 03)

Crepusculo(CG 08)

5/8” x 2 1/2”, 5/8” x 5/8” 3D Glass Mosaics

WAVE

COLLLECTIONN

Azzurro Matte(CGM 04)

Verde(CGB 05)

Sabbia(CGB 06)

Sabbia(CGB 06)

Beige Matte(CGM 02)

275X316X8103/16”x127/16”x5/16”

10 9.601 3516X64X,16X16(5/8x21/2, 5/8x5/8)

Phone: 1.888.862.8397 Fax: 1.888.868.9887

3. Apply set- ting material using the notched side of a 1/4”x1/4” squar- squar- -notched trowel.

4. Smoothen out the setting material using the flat side of the flat side of the trowel; create an even bedding approximately 3/16” thick.

7. Apply the tile sheets onto the setting material. Align the tile sheets carefully, carefully, making sure that the grout lines are parallel with one another.

1. Clean surface of application. Surface should be free of dirt, paint, oils, curing compounds etc.

2. Make sure the back of the tile (and sub-strate) is clean. Wipe with a clean damp sponge.

8. Use a rubber grouting float to apply firm pres-sure onto the tile sheets, cre-ating a level surface.

9. Using a clean damp sponge or cloth, clean any excess set-ting material that may have “oozed” over the tile surface. the tile surface.

11. Apply grout into grout joints using a rubber grouting float. Completely fill the grout joints, be sure that there are that there are

13. When grout has set (or when haze begins to form on the tile surface) clean the tile with a the tile with a clean,damp sponge.

14. For final polishing, use a dry cheese- cloth to polish the tile, within the tile, within 24 hours of grouting.

5. Apply setting mate-rial to the back (mesh-side) of the tile, using a 1/4”x1/4” square-

notched trowel.

6. Smoothen out setting material on the back of the tile sheet, using the flat side of the trowel; Create an even bed-an even bed-

ding.

10. Allow 24-36 hours, after installation, for tile to set before continuing.

no holes while applying grout.

12. Clean any excess grout with a damp sponge or cloth, before grout hardens.