MWM – Martinek Water Management GmbHMozartstraße 23A – 6845 HohenemsAustria

Tel.: +43 5576 75510Fax : +43 5576 78170E – Mail : office@martinek.orgInternet : www.martinek.org

Reducing water loss sustainable …Reducing water loss sustainable …Network survey and leak zone detection …Network survey and leak zone detection …

Detecting leaks immediately ...Detecting leaks immediately ...

WLM - SYSTEM

Cost effective chamber installation Cost effective chamber installation

• Installation without any interruption

• Manufactured by HAWLE Armaturen GmbH

• Easy installation and dismantling

• No chamber necessary; just a street cap

Installation of a pipe saddle Installation of a pipe saddle

•Installation like a house connection

•Use a 38mm driller

Installation of the covering pipeInstallation of the covering pipe

• This part is available in length from 1 to 2,5 m (extra sizes possible)

• Length can be cut on site adapt to the local situation

Installation of WLM-SensorInstallation of WLM-Sensor

• Cable will be put through the extension of the sensor and plugged to it. (all connections are IP68 up to 10m)

• The extension can also be cut on site to the needed length

Top of the extension Top of the extension

• Everything will be covered to avoid water entrance

• A clamp ring will be fixed on the extension for the right depth of the sensor in the pipe

Install the sensor under pressureInstall the sensor under pressure

• A special tool will be used to install the sensor under pressure

• Safety has first priority!

•Installation is finished

Only a small street capOnly a small street cap

• Only a small street cap will be on the top

• Highly vandalism protected!

WLM-System Connection to a street light

Installation in a street cap:12 V charger, modem battery.

Aerial at the top of a street light

Up to ca. 15 m