worldseries sc h1028 0901
TRANSCRIPT
-
8/10/2019 WorldSeries SC H1028 0901
1/4
-
8/10/2019 WorldSeries SC H1028 0901
2/4
-
8/10/2019 WorldSeries SC H1028 0901
3/4
Low HeadroomDesign
Wor l d Ser iesSt andar d Feat ur es
Control Panel
Hoist and t rolley controls are housed
in a common NEMA 4/12 controlenclosure; wi th generous space for ease of
inspection and service. Controls use
only the highest quali ty components
and are designed to meet N EC standards
for maximum life and easy service.
Trolley Traverse Drive
Two wheels are driven; one on each side
of the frame for maximum tracti on anduni form tracking. Traverse motor dri ves a
ri ght angle worm gear reducer for smooth
start ing and stopping (wit hin OSHA requir
distances) wi thout requir ing a brake. Troll
traverse drive pini on shaft is hex-sided; keys
not needed for reducer or pini on connecti on
Each dri ve pin ion is held i n place wi th
locking collars to prevent pi nion walki ng.
Drum, Reeving & Lower Block
Hoist i s reeved to a low-headroom design
lower block for minimum headroom andmaximum lift . Wi re rope is secured to the
drum with three heavy ducti le iron clamps
and designed to have three extra wraps of
wi re rope on the drum wi th the rope at full
extension (low hook).
Block Operated Limit Switch
The hoist is provided wi th a block
actuated upper l imi t switch, meeti ng therequirements of A.S.M .E. The li mit
swi tch is actuated by contact wi th the
lower block, preventing double blocki ng,
possible rope breakage and l oad drop.
Also included is an upper and lower geared
limit swit ch.
Wire Rope Drum & Rope Guide
The wi re rope drum is machined from
quality steel, grooved to a depth equal to50% of the ropes diameter, wi th a rope
guide to help ensure the rope stays in the
grooves.
Hoist Gear Case & Motor
Tri ple reduction hoist gearing is oil bath
lubri cated, operating in an oil- ti ght,vacuum cast aluminum gear case. The
gear case is conveni ent ly located to allow
ease of access in the air, whi le providing
a low headroom design wit h maximum
li ft . The motor is two-speed wi th a 6:1
ratio from high to low speed; givi ng a low
speed for precise load handling and a high
speed for fast thr oughput.
-
8/10/2019 WorldSeries SC H1028 0901
4/4
For additional information, contact your Lift-Tech representative or Lift-Tech headquarters direct.
LIFT-TECH INTERNATIONALDivision of Columbus McKinnon CorporationMUSKEGON, MICHIGAN 49443
414 West Broadway Ave.P.O. Box 769Muskegon, Michigan 49443-0769(800) 742-9269(800) 742-9270 FAX
Printed in U.S.A. / COPYRIGHT 2001, LIFT-TECH INTERNATIONAL, Division of Columbus McKinnon Corporation / BULLETIN NO. LT/SC-H1028-0901
To Avoid Injury:
Do not exceed workingload limit, load rating, orcapacity.
Do not use to lift peopleor loads over people.
Read and follow allinstructions.