written by: tristian cruz - amazon web services › pdf › ifixit › ... · 2019-10-17 · oster...
TRANSCRIPT
Oster BLSTSS-PZO Gear Shaft ReplacementThe gear shaft is responsible for spinning the blades.
Written By: Tristian Cruz
Oster BLSTSS-PZO Gear Shaft Replacement Draft: 2018-01-15Guide ID: 100479 -
This document was generated on 2019-10-16 10:16:32 PM (MST).
© iFixit — CC BY-NC-SA www.iFixit.com Page 1 of 6
INTRODUCTION
The gear shaft is responsible for spinning the blades.
TOOLS:Phillips #1 Screwdriver (1)iFixit Opening Tools (1)Spudger (1)Torque Wrench (1)
4mm SocketSlip Joint Pliers (1)
Oster BLSTSS-PZO Gear Shaft Replacement Draft: 2018-01-15Guide ID: 100479 -
This document was generated on 2019-10-16 10:16:32 PM (MST).
© iFixit — CC BY-NC-SA www.iFixit.com Page 2 of 6
Step 1 — Circuitboard
Use the prying tools to open the fourplastic screw holes on the bottom ofthe blender.
Step 2
Use the Phillips #1 Screwdriver tounscrew the four 16 mm screws andremove the plastic bottom.
Oster BLSTSS-PZO Gear Shaft Replacement Draft: 2018-01-15Guide ID: 100479 -
This document was generated on 2019-10-16 10:16:32 PM (MST).
© iFixit — CC BY-NC-SA www.iFixit.com Page 3 of 6
Step 3
Gently remove the circuit board.
Step 4
Use the spudger to detach the black wire from the circuit board.
Repeat for yellow wire.
Oster BLSTSS-PZO Gear Shaft Replacement Draft: 2018-01-15Guide ID: 100479 -
This document was generated on 2019-10-16 10:16:32 PM (MST).
© iFixit — CC BY-NC-SA www.iFixit.com Page 4 of 6
Step 5
Use the Phillips #1 to remove the four 8mm screws.
Use the medal spudger to detach the circuit board from the buttons.
Gently pull and release circuit board from buttons.
Step 6 — Gear Shaft
Remove the screw on top of the fan with the 4mm socket stock wrench.
Remove the fan and washer.
Oster BLSTSS-PZO Gear Shaft Replacement Draft: 2018-01-15Guide ID: 100479 -
This document was generated on 2019-10-16 10:16:32 PM (MST).
© iFixit — CC BY-NC-SA www.iFixit.com Page 5 of 6
To reassemble your device, follow these instructions in reverse order.
Step 7
Remove the four screws with the 4mm socket stock wrench.
Remove gear shaft.
Oster BLSTSS-PZO Gear Shaft Replacement Draft: 2018-01-15Guide ID: 100479 -
This document was generated on 2019-10-16 10:16:32 PM (MST).
© iFixit — CC BY-NC-SA www.iFixit.com Page 6 of 6