10 february 20041 viewing controller status. 10 february 20042 controller status provides a “snap...
TRANSCRIPT
10 February 2004 1
Viewing Controller Status
10 February 2004 2
Controller Status
• Provides a “snap shot” of the current configuration of controllers on the network– Either one selected controller or all controllers
10 February 2004 3
Open the Controller Window
• Click the tool bar button
OR• Select the Setup >
System pull-down menu option
• Then click on the Controller Status tab
10 February 2004 4
Collecting Controller Status
• Displays controller status– Select one controller and click the button for that
controller’s status– Click the button for the status of all controllers
10 February 2004 5
Viewing Controller Status
• Use the scroll bars to step through all status information and all controllers
10 February 2004 6
Door Name and Controller/Door Address
• Door name lists the text name assigned to each door• Address lists the individual controller/door addresses
10 February 2004 7
Online Status
• Identifies the controller’s online status– - Actively communicating with the network– - Powered off or disconnected from the network, or not
requested by the operator
10 February 2004 8
Controller Type
• Identifies the controller model and configuration– PXL-250 P/W PXL-500/510 P/W Entraguard– SB-293 SB-593– 1 door or 2 door
10 February 2004 9
ROM Revision / RAM Configuration
• Identifies the controller’s ROM firmware revision• Identifies the controller’s RAM size
– RAM size correlates to the number of users that can be assigned to the controller
10 February 2004 10
Events / Users in Memory
• Lists the number of events currently stored in the controller (maximum of 3,640)
• Lists the number of users stored in the controller’s memory
10 February 2004 11
Date and Time
• Lists the date and time the controller status information was collected
10 February 2004 12
Cold and Warm Resets
• Lists the number of times the controller’s power has been cycled off and on
• Lists the number of times the controller’s microprocessor reset itself
10 February 2004 13
POST Failures
• Lists the number of times the controller’s power on self test failed– Indicative of a RAM or controller power issue
10 February 2004 14
Local APB
• Identifies if local anti-passback has been enabled for that controller
10 February 2004 15
Access Enabled
• Identifies if the controller’s reader is currently turned on (enabling access control reading) or off (disabling access control reading)
10 February 2004 16
Reader Type
• Lists the type of reader connected to the controller– Proximity or Wiegand
10 February 2004 17
Door Status and Door Lock
• Lists the state of the door status switch on the door at the time controller status was read
• Lists the status of the door lock at the time controller status was read
10 February 2004 18
Door Open Time / Unlock Time
• Lists the number of seconds a door can be held open before a “door held open” alarm is generated
• Lists the number of seconds that a door’s lock relay will be active following a valid access request
10 February 2004 19
Door Unlock Timezone
• Lists the unlock timezone that has been assigned to the door
10 February 2004 20
First Person In
• Lists the First Person In value assigned to that door
10 February 2004 21
Door Forced / Door Held Outputs
• Lists the output where a door forced alarm will be directed
• Lists the output where a door held open alarmwill be directed
10 February 2004 22
Primary and Auxiliary RTE
• Lists the action taken by the controller when a Primary or Auxiliary RTE signal is received