8/8/2019 10 Up Cadillac Cts Sport Wagon Rear Grille Installation Manual Carid

1/4

8/8/2019 10 Up Cadillac Cts Sport Wagon Rear Grille Installation Manual Carid

2/4

9. Once the frame is removed, use a 3/32 drill bit to drillthrough the mounting tab marks and into the factorychrome moulding (two holes per side). Drill through themarks made in the trunk lid where the lower mountingtabs will attach to the trunk lid.

9

10 . Cut the supplied piece of 1 double faced tape into threeequal sections and install them onto the back of thepowder coated rear tag filler. Be sure to install the tapeon the back of the part (the side where the part numberlabel is applied). Make sure you place the tape at the topedge of the tag filler.

10

12. Align the chrome plated mesh section over the powdercoated filler and use masking tape to keep the mesh prop-erly aligned with the fille.

11. Install the powder coated plate by peeling off the doublefaced tape backing, align the part tightly against the topof the tag recess and press firmly into place.

13. Reinstall the T-10 Torx pin head screws to secure the sur-round to the trunk lid. DO NOT OVERTIGHTEN OR YOUWILL STRIP OUT THE M OUNTING HOLES! Make sure themesh is not caught behind the lower mounting tabs.

11

1213

14. If the mesh section is slightly loose, the rear tag assemblywill hold it firmly in place once it is installed.

8/8/2019 10 Up Cadillac Cts Sport Wagon Rear Grille Installation Manual Carid

3/4

9. Once the frame is removed, use a 3/32 drill bit to drillthrough the mounting tab marks and into the factorychrome moulding (two holes per side). Drill through themarks made in the trunk lid where the lower mountingtabs will attach to the trunk lid.

9

10 . Cut the supplied piece of 1 double faced tape into threeequal sections and install them onto the back of thepowder coated rear tag filler. Be sure to install the tapeon the back of the part (the side where the part numberlabel is applied). Make sure you place the tape at the topedge of the tag filler.

10

12. Align the chrome plated mesh section over the powdercoated filler and use masking tape to keep the mesh prop-erly aligned with the fille.

11. Install the powder coated plate by peeling off the doublefaced tape backing, align the part tightly against the topof the tag recess and press firmly into place.

13. Reinstall the T-10 Torx pin head screws to secure the sur-round to the trunk lid. DO NOT OVERTIGHTEN OR YOUWILL STRIP OUT THE M OUNTING HOLES ! Make sure themesh is not caught behind the lower mounting tabs.

11

1213

14. If the mesh section is slightly loose, the rear tag assemblywill hold it firmly in place once it is installed.

8/8/2019 10 Up Cadillac Cts Sport Wagon Rear Grille Installation Manual Carid

4/4