8/13/2019 10ft SMA-WK-10 Wind Kit 250kmh (NMT205-07)

1/2

NMT 205-07(e)

It is important to mount the antenna exactly as described in this installation instruction.

The installed antenna shall be inspected once per year by qualified personnel.

RFS disclaims any responsibility for the result of improper or unsafe installation.

This installation instruction has been written for qualified, skilled personnel.

We reserve the right to alter details, especially with respect to technical improvement.

Sales department : Radio Frequency Systems GmbH

Kabelkamp 20, D-30179 Hannover (Germany) - Tel. +49-511 676-25 20 - Fax +49-511 676-25 21

Plant : RFS France Trignac - Fax +33 02 40 90 41 43 1/2

1. Description

All standard 10 ft antennas withstand a survival windspeed of 200 Km/h. These antennas can equippedwith a WindKit for a survival wind speed of 250 Km/h.

These 250 km/h WindKit is composed of :

- 6 stiffening steel pipes - 1 hardware pack - 1 U elevation renforced profil (in replacement of elevation angle supplied with the antenna)

2. Tool required for installation

- Wrenches for hexagon bolts or nuts HM12 (19 mm), HM20 (30 mm) - Torque wrenche from 50 to 240 Nm - Electric drill with 13 mm drill bit (for antenna equipped with hemispherical radome)

3. Assembly of the mount

Installation Instructions

Microwave Parabolic 10 ft Antennas 250 km/h WindKit

Kit : SMA-WK-10

Antenna with Standard Backring

Kit : SMA-WK-10

Replace the elevationangle supplied with

the antenna by the

U profile delivered in

the kit

Screw M20x60

(in the kit)

Washer 13

(with ant.)

Washer 13

(with ant.)

SL nut M12

(in the kit)

Do not use the galvanized steel

SL washers 12 and screws

M12x50 provided with the

antenna

8/13/2019 10ft SMA-WK-10 Wind Kit 250kmh (NMT205-07)

2/2

2/2NMT 205-07(e)

4. Assembly of the steel pipes

Note : For antenna with shroud or hemispherical radome, you need to substitute the 6 M5 or M6 bolts(installed in holes 13) of the reflector rim, by the M12x40 bolts provided in 250 km/h hardware pack.For hemispherical radomes, the holes used for stiffening pipes attachment must be oversized to13 mm.

- Install the 6 stiffening steel pipes between the reflector rim and the antenna backring, hantighten theM12 bolted joints

- After complete handtightening, torque tighten all bolted joints in opposite diagonal mode (refer totorque table joined)

(x6) 1 screw M12x30 (in M12 inserts of the backring)(x6) 1 SL washer 12

(x6) 1 washer 13

(x6) 1 washer 13 37

(x6) 1 screw M12x40 (in hole 13 mm)

2/2

5. Next instructions (See installation instructions supplied with the antenna)

Antenna with Standard Backring

Kit : SMA-WK-10

Top

Reflector rim

Backring(x6) 1 nut M12

(x6) 1 SL washer 12

(x6) 1 washer 13