REMOTE DETECTOR

USER MANUAL

Remote Detector can check the serviceability and signal power of Remote Controls (Radio Frequency 315MHz, 433MHz and 868MHz and Infra Red signal).

Functions:

1. Radio Frequency remote control operation checking (0MHZ - 1,2GHz).2. Infra Red remote control operation checking.

Basic Operations.

Press white button to switch Remote Detector ON.

The Radio Frequency value and battery voltage (Detector voltage supply) will appear on LCD. The battery voltage value will light out in 20 seconds. If battery voltage will less than 8.3 Volts you should to change the battery. When you buy the Remote Detector it has the test battery inside. Place the Remote Control near the receiver (see photo) and press any button.Check the operation of all buttons of the Remote.

- The Remote Controls for American market use Radio Frequency 315MHz.

- The Remote Controls for European market use Radio Frequency 433MHz.

- And some new Remote Controls with Philips 46 Crypto 2 transponders use Radio Frequency 868MHz.

Infra Red Remote Control Checking.

You can check Infra Red signal too. Point IR Remote Control at receiver and press any button on remote.

The “IR” symbol will appear on LCD.

Press white button once again to switch Remote Detector OFF.

power signal level