2g bbulbe pass instructions-5 replacement of heater
TRANSCRIPT
2G BBULBE
PASS Instructions-5Replacement of Heater
Heater
Instructions
1. Take off water inlet and outlet fittings 2. Deflate spa
3. Remove cord grip with screwdriver 4. Remove the air pipe
5. Take out control box from spa pool 6. Remove the foam
7. Loosen the screws on the top lid 8. Remove the top lid
Instructions
Instructions
Bubble
Power input
Transformer input
Heater
Filter Transformer output
3 PIN-
water switch
2 PIN -Sensor
9. Disconnect the wires 10. SPA power panel
11. Remove the middle part of control box hull 12.Replace the heater
Instructions
13. Assembly the middle part of control box hull 14. Connect the wires
15. Put the top lid of control box 16. Put on the foam
Instructions
17. Assembly the control box 18. Pull out the air pipe through spa tub
19. Connect the check valve with spa tub 20. Screw back water inlet and outlet tightly
Instructions
Please give your valuable opinion!