i7.5MT14-01

(3) Metal Stakes on nylon cord(1) Spare Parts Bag

CAUTION: EXERCISE CARE WHEN UNPACKING AND ASSEMBLING WARNING: Risk of fire and electric shock Disconnect light set from power before starting.1) Keep wires clear of being pinched or cut during assembly or installation.2) Do not press or grasp bulbs during assembly or installation.3) Before starting make sure stakes are clear of underground: sprinkler, telephone and power lines.4) Please read all instructions and warnings included with this product before using.

Approximate assembly time is 10-15 minutesHammer/Mallet may be required for stakes

Parts List:(1) 3-Piece Stand

300L 7.5' Mini iTwinkle Metal Tree Assembly Instructions

(1) 3-section Telescopic Pole with: (3) Arc Light Sections (1) Attached Star Top(1) iTwinkle Power Supply/Speaker

Assembly Steps1) Remove contents from the carton by untwisting the (2) twist ties. Carefully remove all packing material. {Fig. 1} Retain shipping box to repack your tree.2) Assemble the base legs by sliding each leg over the post while depressing the spring-loaded buttons. {Fig. 2}3) Remove the red protective cap at end of pole. Place pole onto the center base post. The thumbscrew must align over the base leg having "1" at the end. Tighten thumbscrew. {Fig. 3}.4) Fully insert the treetop post. {Fig. 4}5) Telescope up the other two pole sections until both snap in place. {Fig. 5}6) Hang the speaker onto the post on the tree pole as shown in {Fig. 6}7) Remove the (2) twist ties securing the light strings to the metal frame for the 3 arc sections and bring down. {Fig. 7} Rotate an arc section, if the strings are twisted.CAUTION: To avoid damage do not place the metal frame on glass bulbs.8) Within each arc section remove the upper and (2) lower twist ties. Untangle the strands as necessary.9) Connect the 2 arc sections marked "1" to the right and left of the base as shown in {Fig. 8}. Connect the third arc section. All three "1" must be in alignment.10) Your outdoor tree is now fully assembled. {Fig. 10}To secure tree in place use the (3) metal stakes attached to nylon cords. {Fig. 9}. Unhank each of cord and secure into the ground to stabilize your tree.11) Fully insert the plug from the iTwinkle speaker into an approved working outlet. The blinking blue light on the speaker means the unit is searching for an available Bluetooth connection to your device.Note: 1. All bulbs should be lighted. If any bulb does not light, check bulb for security in lamp holder. Also, carefully check for any bulbs that may have broken in transit or during assembly. Replacement bulbs provided. See separate instructions for replacing bulbs (enclosed). 2. Connect up to three 150-light mini light Sculptures. Total system not to exceed 420Watts (3.5A). 3. To disassemble the tree please follow the instructions in reverse order and place in original carton.

1 1

1

Fig. 5 Fig. 7 Fig. 6

Fig. 8

Item No. 00612

11

Fig. 2

1

Fig. 3 Fig. 4

Fig. 1

Fig. 9

Fig.10