3d micromanufacturing lab. [1] drying oven. [2] 3d micromanufacturing lab. what is a drying oven an...
TRANSCRIPT
3D Micromanufacturing Lab.[1]
Drying Oven
[2] 3D Micromanufacturing Lab.
What is a Drying Oven• An oven is a thermally insulated chamber used for the heating or drying
of a substance using hot air that flows inside the oven.
• When the pipette tips are autoclaved then water droplets are adhered on the tips.
• This water droplets could change the concentration of solutions which is handled by using pipette.
• In our lab, majorly we use this oven to dry the pipette tips after they have been autoclaved.
[3] 3D Micromanufacturing Lab.
Settings
• Normally, this drying oven is set at 60°C for 3-4 hours to dry water droplets from pipette tips.
• Temperature and timer can be set by pressing ‘Mode’ and then changing the values using ‘left’ and ‘up’ keys.
[4] 3D Micromanufacturing Lab.
SpecificationsMODEL HST-501S
Dimension (IN) 450x450x450 (H) mm
(OUT) 550x580x800 (H) mm
Capacity 91 Litre
Shelves 2 EA
Temp. controller Digital PID Controller
Temp. Range Ambient +5' C to 220'C
Temp. Accuracy ± 1.5 'C at 100'C
Temp. Sensor PT100Ω
Timer Digital Timer 99hr 59min. or Infinity
Material (IN) Stainless Steel (SUS304) Polishing Plate
(OUT) SCP-1 With Powder Coating
Door Silicon Packing Door With Window
Safety Device Hydraulic Temperature Controller
Port Exhaust Hole x 2EA
Power (AC 220V, 60HZ) 800W