4d-boardtester ii - iwatsu · board sizes up to 300 x 340 mm can be tested with the 4d boardtester...
TRANSCRIPT
© 2012 PMK GmbH
1
4D-Boardtester II
The 4D Boardtester II is the perfect solution for hardware design and electronic development
workbenches in applications like testing, verifing, trouble-shooting and debugging of electronic
circuits.
Boards with sizes up to 300 x 340 mm can be flex-clamped variable with gliding tracks for board
floating heights of up to 160 mm. PMK 3D Positioners with magnet feet can be placed from both
sides on the gliding tracks (from above and from below !). The 3D Positioners allow contacting
measuring points from various angles over the whole work space.
Supplied with the 4D Boardtester II are 2 units of 3D Positioners with magnet feet: one compact,
very flexible miniature positioner with a span width of 130 mm and a magnet holding force of 170 N
and our standard 3D positioner with a span width of 200 mm and a magnet holding force of 300 N.
Our universal PMK 3-fold holder comes with both positioners. It is applicable with all PMK 2.5 mm
and 5 mm probes as well as other test and near field probes.
Ask for customized solutions, if the shown setup does not meet your requirements.
Features:
Handsfree Testing and Measuring
Accurate and Safe Positioning
Variable Arrangement of the Positioners by Magnet Feet
Positioning System for Scope-Probesand other measuring Devices
© 2012 PMK GmbH
2
4D-Boardtester II
Datasheet
This datasheet supersedes all previously published material. Specifications that are defined typical are not guaranteed and are published as general information to the user.Note that specifications are subject to change without notice.
Board sizes up to 300 x 340 mm can be tested with the 4D Boardtester II
For ESD protection (electrostatic discharge) the 4D Boardtester II can be grounded at all four corners near the bottom via a fasten connector. A 200 cm EDS wristband is included in the scope of delivery.
340 mm max.
300
mm
max
.16
0 m
m
© 2012 PMK GmbH
3
4D-Boardtester II
Datasheet
Part No. Type Name Description
893-400-002 BT II 4D 4D Boardtester II PMK 4D Boardtester II 300 x 340 mm, incl. 1 piece each positioner MSM 130 and MSM 200 and ESD 200 mm wrist- band893-350-004 MSM 130 Positioner 130 M PMK 3D positioner with magnet foot (170 N holding force), span width 130 mm, both sided M6, incl. PMK 3-fold holder
893-350-005 MSM 200 Positioner 200 M PMK 3D positioner with magnet foot (300 N holding force), span width 200 mm, both sided M6, incl. PMK 3-fold holder
Manufacturer
PMK Mess- und Kommunikationstechnik GmbHKönigsteiner Str. 9865812 Bad Soden, Germany Internet: www.pmk-gmbh.com
Tel: +49 (0) 6196 5927 - 930 E-Mail: [email protected]
Fax: +49 (0) 6196 5927 - 939 [email protected]
Revision A – February 2012